A.By default， all defined VLANs are allowed on the trunk.
B.Each single VLAN， or VLAN range， must be specified with the switchport mode command.
C.Each single VLAN， or VLAN range， must be specified with the vtp domain command.
D.Each single VLAN， or VLAN range， must be specified with the vlan database command.
您可能感興趣的試卷
你可能感興趣的試題
A.It is supplied by the CSU/DSU.
B.It is supplied by the far end router.
C.It is determined by the clock rate command.
D.It is supplied by the Layer 1 bit stream timing.
A.A WPA key is longer and requires more special characters than the WEP key.
B.The access point and the client are manually configured with different WPA key values.
C.WPA key values remain the same until the client configuration is changed.
D.The values of WPA keys can change dynamically while the system is used.
A.The router will use the static route.
B.The router will use the OSPF route.
C.The router will use the EIGRP route.
D.The router will load balance and use all three routes.
A.neighbor table
B.SPF table
C.RTP table
D.topology table
E.query table
F.DUAL table
A.1024
B.2046
C.4094
D.4096
E.8190
最新試題
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?（）
At which layer of the OSI model dose PPP perform?（）
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
On which options are standard access list based?（）
Which statement is true, as relates to classful or classless routing?（）
How are VTP advertisements delivered to switches across the network?（）