A. source address and subnet mask
B. destination address and wildcard mask
C. source address and wildcard mask
D. destination address and subnet mask
您可能感興趣的試卷
你可能感興趣的試題
A. Main(config)#interface serial 0/0 Main(config-if)#ip address 172.16.1.1 255.255.255.252 Main(config-if)#no shut
B. Main(config)#interface serial 0/0 Main(config-if)#ip address 172.16.1.1 255.255.255.252 Main(config-if)#encapsulation ietf Main(config-if)#no shut
C. Main(config)#interface serial 0/0 Main(config-if)#ip address 172.16.1.1 255.255.255.252 Main(config-if)#encapsulation frame-relay Main(config-if)#authenication chap Main(config-if)#no shut
D. Main(config)#interface serial 0/0 Main(config-if)#ip address 172.16.1.1 255.255.255.252 Main(config-if)#encapsulation ppp Main(config-if)#no shut
A. defines the source IP address that i s used in all broadcast packets on DLCI 202
B. defines the DLCI that is used for all packets that are sent to the 192.168.1.2 IP address
C. defines the destination IP address that is used in all broadcast packets on DLCI 202
D. defines the DLCI on which packets from the 192.168.1.2 IP address are received
A. anycast frames
B. multicast frames
C. broadcast frames
D. unicast frames
A. OSPF and mumber of hops and reliability
B. EIGRP and link cost
C. IS-IS and delay and reliability
D. RIPv2 and number of hops
A. dual stack
B. dynamic
C. Teredo
D. Manual 6to4
最新試題
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?（）
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?（）
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?（）
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?（）