單項選擇題When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the interface clock rate determined?()

A.It is supplied by the CSU/DSU.
B.It is supplied by the far end router.
C.It is determined by the clock rate command.
D.It is supplied by the Layer 1 bit stream timing.


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題What is one reason that WPA encryption is preferred over WEP?()

A.A WPA key is longer and requires more special characters than the WEP key.
B.The access point and the client are manually configured with different WPA key values.
C.WPA key values remain the same until the client configuration is changed.
D.The values of WPA keys can change dynamically while the system is used.

2.單項選擇題A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network?()

A.The router will use the static route.
B.The router will use the OSPF route.
C.The router will use the EIGRP route.
D.The router will load balance and use all three routes.

3.多項選擇題Which tables of EIGRP route information are held in RAM and maintained through the use of hello and update packets? (Choose two.)()

A.neighbor table
B.SPF table
C.RTP table
D.topology table
E.query table
F.DUAL table

5.多項選擇題Which two practices help secure the configuration utilities on wireless access points from unauthorized access? (Choose two.)()

A.assigning a private IP address to the AP
B.changing the default SSID value
C.configuring a new administrator password
D.changing the mixed mode setting to single mode
E.configuring traffic filtering

最新試題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型:?jiǎn)雾?xiàng)選擇題

How are VTP advertisements delivered to switches across the network?()

題型:?jiǎn)雾?xiàng)選擇題

Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?()

題型:?jiǎn)雾?xiàng)選擇題

Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()

題型:?jiǎn)雾?xiàng)選擇題

An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?()

題型:?jiǎn)雾?xiàng)選擇題

Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()

題型:?jiǎn)雾?xiàng)選擇題

Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()

題型:?jiǎn)雾?xiàng)選擇題

After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()

題型:?jiǎn)雾?xiàng)選擇題

When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()

題型:?jiǎn)雾?xiàng)選擇題

Which command encrypts all plaintext passwords?()

題型:?jiǎn)雾?xiàng)選擇題