A customer has 20 E1s to add between far-end nodes in an SNCP ring.
What type of circuit would you recommend？（）
A. LO-PATH circuits
B. HO-PATH circuits
C. 1：1 protection circuits
D. 1：N protection circuits
E. LO-PATH tunnel circuits
您可能感興趣的試卷
你可能感興趣的試題
Click the Exhibit button. As shown in the exhibit， a customer has several interconnected core rings. They want to create several irtual rings？utilizing their STM-64 backbone （nodes 1， 2， 3， and 4）.
What do you recommend？ （）
A. SNCP rings
B. MS-SPRing rings
C. 1：N protection on all core circuits
D. dual-ring interconnect with MS-SPRing rings
A customer has 2 E1s to add between far-end nodes in an SNCP ring.
What type of circuit should you recommend？ （）
A. LO-PATH circuits
B. HO-PATH circuits
C. 1：1 protection circuits
D. 1：N protection circuits
E. LO-TUNNEL tunnel circuits
A. signal fail， signal degrade， manual switch
B. signal degrade， signal fail， manual switch
C. protection lockout， manual switch， path AIS
D. forced switch， manual switch， signal degrade
E. protection lockout， manual switch， forced switch
A. LEX
B. HDLC
C. GFP-F
D. PPP/BCP
You are provisioning an E-1 circuit on an ONS 15454 MS-SPRing configuration and XC-VXL-10G card. Each VC-12 connection must also terminate via the VC-3 matrix.
How many VC-3 ports remain after this circuit is created， assuming no other circuits？（）
A. 92
B. 93
C. 94
D. 95
E. 96
最新試題
Click the Exhibit button. Which type of multiplexer is shown in the exhibit？（）
What are two important considerations when using 2- or 4-channel 15216 OADMs？（）
What are three relevant design considerations when using the 15216 EDFA？（）
The dispersion of a non-zero dispersion shifted fiber is 6 ps/nm*km at 1550 nm and 10 ps/nm*km at 1610 nm. What is the minimum dispersion compensation required if an L-Band DWDM signal travels through 200 km of fiber and has a dispersion tolerance of 1800 ps/nm？（）
How is a Thin Film filter fabricated？ （）
In the OSNR model for EDFA amplifiers， SNR OUT = 1/（1/SNR IN + FhvB/P IN ）， what does SNR IN represent？（）
Click the Exhibit button. When designing a DWDM system with multiple amplified spans， a pre-amp is needed at Site B to （）.
Which timing mode is appropriate for an SDH NE that is adjacent to an SDH NE Bits-1 timing？ （）
In order to avoid misconnections due to a failed node in an MS-SPRing， Alarm Indication Signals （AISs） are sent on every channel normally terminating in that node. What is the name of this process？（）
What is the phenomenon called where different wavelengths of light travel at different speeds？（）