You are trying to change the polling parameters used by the location manager via the Cisco WCS， and yourrequest is being denied.
What is wrong？（）
A.Your login does not have the correct permissions.
B.You must wait for the location server to become available.
C.Polling values can be changed only on the location server.
D.Polling values can be changed only in the maintenance window.
您可能感興趣的試卷
你可能感興趣的試題
During the installation of the Cisco WCS version 4.0， an error occurs.
Where would you look for theinstallation log， in order to learn more about this error？（）
A.in the Cisco WCS installation directory
B.at the root of the installation drive
C.in the Cisco WCS\Logs directory
D.on the desktop of the server
A.Multiple controller-based access points will load-balance the containment task using fewer resources than a single access point.
B.Clients connected to the rogue access point may be out of the range of the controller-based access point providing containment.
C.Each controller-based access point can handle only a limited amount of clients connected to the rogue access points.
D.Clients connected to the rogue access point must be able to connect to the containment controller-based access point.
A.three
B.four
C.five
D.six
A.1
B.5
C.10
D.15
A.50
B.128
C.512
D.1024
最新試題
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.What is the maximum number of WLAN controllers that you can add？（）
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）
If it is properly deployed， a controller-based access point is capable of monitoring all VLANs on anetwork when you select which of the following modes from the AP Mode drop-down menu onthe controller？（）
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to？（）
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）
You review the Failed Attempts logs on an AAA server and find： "unknown network access servererror." Which failure could produce this error？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）