A.Multiple controller-based access points will load-balance the containment task using fewer resources than a single access point.
B.Clients connected to the rogue access point may be out of the range of the controller-based access point providing containment.
C.Each controller-based access point can handle only a limited amount of clients connected to the rogue access points.
D.Clients connected to the rogue access point must be able to connect to the containment controller-based access point.
您可能感興趣的試卷
你可能感興趣的試題
A.three
B.four
C.five
D.six
A.1
B.5
C.10
D.15
A.50
B.128
C.512
D.1024
In a deployment using standalone access points， clients set up to authenticate with EAP-PEAP or EAP-Cisco Wireless （Cisco-LEAP） cannot authenticate. When you inspect the Failed Attempts report on theCisco Secure ACS， you find this error： "Unknown network access server NAS."
Which problem may havecaused this failure？（）
A.misconfigured EAP type on the access point
B.misconfigured EAP type on the AAA server
C.misconfigured IP address of the access point on the AAA server
D.misconfigured IP address of the AAA server on the access point
You are configuring a wireless LAN controller for QoS.
Which 802.11e user priority tag should you apply tovoice applications？（）
A.1
B.3
C.4
D.6
最新試題
You have a very few Cisco 7920 wireless IP phones on your network， but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller？（）
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
You are using ADU and are authenticated and associated to an access point. However， you are unable to obtain an IP address.Which of these has caused this problem？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but， when you answer， the call is dropped.What may cause this problem？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor，4GB RAM， and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem？（）
On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter，the status LED and activity LED are alternating on and off.What does this indicate？（）
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）
Clients using Cisco-LEAP and EAP-FAST authentication are having no problems logging on to thewireless network， but clients using PEAP are failing to log on.Which situation would result in thistype of problem？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）