Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?（）

Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?（）

Which keyword is used with the show ip bgp neighbors [keyword] command to display all routes that are received and accepted from a neighbor?（）

When a Cisco router is configured for SSH, it acts as an （）?

You are an experienced network administrator in an international corporation. One of your clients asks you to configure a network for a financial trading center which requires multiple high-value transactions.And the transactions are very important to the client. In such a situation, which two of the following are basic and most important requirements concerning the configuration? （）(Choose two.)

You have just reinstalled a VIP 6-80 in a Cisco 7500 Series router. What must you do to bring up the port adapter interfaces?（）

Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? （）(Choose two.)

In a high-availability network, which command, when placed on ports that have connected end stations, will allow you to prevent delays in service for end stations by placing a port in blocking mode?（）

Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?（）

What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）