A.voip
B.rfid tags
C.data collection
D.802.11b and g clients
您可能感興趣的試卷
你可能感興趣的試題
The ios of a north american cisco aironet 1230 series access point has become corrupt,
necessitating the need for a tftp firmware reload.
Before you press and hold the mode button,what must the file be named in order for the reload to occur?()
A.c1200-k9w7-tar.default
B.c1200-k9w7-tar.boot
C.c1200-k9w7-tar.123-7.ja1.tar
D.c1200-k9w7-tar.recover
lightweight access point has been connected to a catalyst 3550 24-pwr switch, and on power-up the access point fails.
What is the problem with the switch?()
A.the power supply has inadequate wattage.
B.power is incorrectly configured on the port.
C.it does not support 802.3af poe.
D.power is not enabled on the port.
Two access points running the core feature set are connected to the same switch and are
providing guest services. if pspf is enabled.
What must be enabled on the switch to prevent clients from seeing one another’s data?()
A.port-based radius
B.802.1q trunking
C.inline power
D.protected port
A.startup
B.site survey mode
C.lost connection to the controller
D.duplicate ip address
Last december you erected a bridge link between two buildings on your campus. it is now april and the foliage in the trees is full, and the bridge link will no longer maintain connectivity.
Which action will most likely solve the problem?()
A.change the channel selection.
B.install higher gain antennas.
C.raise the antennas.
D.increase transmitter power.
最新試題
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.What is the maximum number of WLAN controllers that you can add?()
When configuring Cisco Secure ACS to support wireless EAP authentication, which device must be configured as a AAA client?()
On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter,the status LED and activity LED are alternating on and off.What does this indicate?()
You are using ADU and are authenticated and associated to an access point. However, you are unable to obtain an IP address.Which of these has caused this problem?()
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem?()
You have a very few Cisco 7920 wireless IP phones on your network, but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller?()
Static WEP is configured on the access point. You are authenticated and associated to the accesspoint but are unable to obtain an IP address.Which of the following will cause this problem?()
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference?()
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones,which two general control settings should you select?()
On a Cisco Aironet 1240AG Series standalone access point, the radio LED is dark blue and blinking,but the status LED and Ethernet LED are both off.What does this indicate?()