Two access points running the core feature set are connected to the same switch and are
providing guest services. if pspf is enabled.
What must be enabled on the switch to prevent clients from seeing one another’s data？（）
A.port-based radius
B.802.1q trunking
C.inline power
D.protected port
您可能感興趣的試卷
你可能感興趣的試題
A.startup
B.site survey mode
C.lost connection to the controller
D.duplicate ip address
Last december you erected a bridge link between two buildings on your campus. it is now april and the foliage in the trees is full， and the bridge link will no longer maintain connectivity.
Which action will most likely solve the problem？（）
A.change the channel selection.
B.install higher gain antennas.
C.raise the antennas.
D.increase transmitter power.
An 802.1x client cannot authenticate to an autonomous access point configured for multiple vlans. the native vlan does not have an ssid configured.
Which one of the following links being down would prevent the clients from authenticating？（）
A.between the radius and the access point
B.between the client’s vlan and the wlse
C.between the native vlan and the wlse
D.between the client’s vlan and the radius
A.1
B.4
C.2
D.5
E.3
In a deployment using the lightweight access points， clients set up to authenticate with eap-peap or eap-cisco wireless （leap） cannot authenticatE. upon inspection of the failed attempts report you see the following error： "unknown network access server nas."
What two problems can cause this type of failure？（）
A.misconfigured ip address of the aaa server on the wireless controller
B.misconfigured ip address of the wireless lan controller on the aaa server
C.misconfigured eap type on the wireless lan controller
D.misconfigured shared secret on the wireless lan controller
E.misconfigured eap type on the aaa server
最新試題
Which of the following accurately represents the functionality of a lightweight access point configured to operate in sniffer AP mode？（）
On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter，the status LED and activity LED are alternating on and off.What does this indicate？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem？（）
You are installing a Cisco Aironet 1000 Series controller-based access point. When you boot it， allthe LEDs on the access point blink together.What does this indicate about the access point？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS？ （）