A.network connections
B.location views
C.access points
D.object definitions
您可能感興趣的試卷
你可能感興趣的試題
Yours truly， have been called upon to add location-based services into an existing controller-based wireless design which primarily encompasses handheld devices such as barcode scannersand cisco 7920 wireless ip phones.
In which mode should you deploy the additional access points to achieve the density required without excessive co-channel interference？（）
A.tracking mode
B.monitor mode
C.location mode
D.sniffer mode
A cisco aironet 1020 controller-based access point has been connected to a catalyst 3550-24 pwr switch. however， when it is powered up， the access point fails.
What has caused this problem？（）
A.access point does not support 802.11h
B.incorrect switch power supply
C.switch port is not enabled
D.switch does not support 802.3af
E.access point has not been initialized with the primary controller
A.acceptance test plan
B.change management
C.incident management
D.configuration management
A.ongoing support handoff meeting
B.staff training
C.detailed design development
D.staging and system migration
On a standalone access point， client association using eap-cisco wireless （cisco-leap） is failing， but association using eap-peap is functioning.
What needs to be enabled on the standalone access point to correct this issue？（）
A.network eap
B.open authentication plus mac
C.open authentication plus eap
D.a shared key
最新試題
On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter，the status LED and activity LED are alternating on and off.What does this indicate？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
On a WLAN controller， what is the default roaming bandwidth percentage reserved for voice clients？（）
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.What is the maximum number of WLAN controllers that you can add？（）
You are using ADU and are authenticated and associated to an access point. However， you are unable to obtain an IP address.Which of these has caused this problem？（）
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）
You are trying to change the polling parameters used by the location manager via the Cisco WCS，and your request is being denied. What is wrong？（）
You are installing a Cisco Aironet 1000 Series controller-based access point. When you boot it， allthe LEDs on the access point blink together.What does this indicate about the access point？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）