A.pleting aggressive implementation schedule
B.Stateful Switchover
C.pany and user expectations
D.Nonstop Forwarding
E.change control processes
F.dual devices and dual links
您可能感興趣的試卷
你可能感興趣的試題
A.jitter
B.delay
C.PoE
D.bandwidth
E.packet loss
During voice implementation，
which two required items are configured at an access layer switch connected to an IP phone to provide VoIP communication？（）
A.allowed codecs
B.native VLAN
C.auxiliary VLAN
D.Cisco Unified Communications Manager IP address
E.RSTP
A network is deployed using best practices of the enterprise campus network model， including users with desktop computers connected via IP phones. Given that all components are QoS-capable，
where are the two optimal locations for trust boundaries to be configured by the network administrator？（）
A.host
B.IP phone
C.access layer switch
D.distribution layer switch
E.core layer switch
Wireless has been operating correctly in the campus infrastructure. After the wireless controllers are upgraded from LWAPP to CAPWAP， access points no longer boot and operate normally.
What is the most likely issue causing this problem？（）
A.VLAN assignments
B.DHCP option 43
C.PoE
D.ACL
E.QoS
A standalone wireless AP solution is being installed into the campus infrastructure. The access points appear to boot correctly， however， wireless clients are not obtaining correct access. You verify that the local switch configuration connected to the access point appears as the following：
interface ethernet 0/1
switchport access vlan 10
switchport mode access
spanning-tree portfast
mls qos trust dscp
What is the most likely issue causing the problem？（）
A.QoS trust should not be configured on a port attached to a standalone AP.
B.QoS trust for switchport mode access should be defined as "cos".
C.switchport mode should be defined as "trunk" with respective QoS.
D.switchport access vlan should be defined as "1".
最新試題
Refer to the exhibit. What does the command channel-group 1 mode desirable do？ （）
During routine maintenance， G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However， after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ？ （）
Which two statements about the various implementations of STP are true？（）
Refer to the exhibit. For what purpose is the command show ip cef used？（）
Which option correctly identifies the Cisco IOS switching methods in descending order from the fastest method to the slowest method？（）
Which statement is correct about the use of the virtual interface on a WLC ？（）
What must be the same to make multiple switches part of the same Multiple Spanning Tree （MST）？（）
Based on the show spanning-tree vlan 200 output shown in the exhibit， which two statements about the STP process for VLAN 200 are true？ （）
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2？（）
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result？（）