A. per host using a round robin scheme
B. per host using a strict priority scheme
C. per session using a round robin scheme
D. per session using a strict priority scheme
E. per GLBP group using a round robin scheme
F. per GLBP group using a strict priority scheme
您可能感興趣的試卷
你可能感興趣的試題
Which one of the statements below correctly describes the Virtual Router Redundancy Protocol (VRRP),
which is being used in the Company network to provide redundancy?()
A. A VRRP group has one active and one or more standby virtual routers.
B. A VRRP group has one master and one or more backup virtual routers.
C. A VRRP group has one master and one redundant virtual router.
D. None of the other alternatives apply
HSRP has been configured between two Company devices.
What kind of message does an HSRP configured router send out every 3 seconds?()
A. Retire
B. Coup
C. Resign
D. Send
E. Hello
To protect against first-hop router failure, four protocols were developed to ensure IP routing redundancy.
Which of the following are they?()
A. HSRP
B. IRDP
C. ICMP
D. VRRP
E. MSTP
F. GLBP
HSRP is being set up between two Company devices.
In what three states is it possible for an HSRP router to be in?()
A. Standby
B. Established
C. Active
D. Idle
E. Backup
F. Init
R1 and R2 exchange HSRP between each other in the Company network.
In which three HSRP states do routers send hello messages?()
A. Learn
B. Speak
C. Standby
D. Listen
E. Active
F. Remove
最新試題
Which router redundancy protocol cannot be configured for interface tracking?()
If G1/0/1 on DS1 is shutdown, what will be the current priority value of the Vlan105’s group on DS1 ?()
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2?()
What must be the same to make multiple switches part of the same Multiple Spanning Tree (MST)?()
How are STP timers and state transitions affected when a topology change occurs in an STP environment?()
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals?()
During routine maintenance, G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However, after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ? ()
Which two statements are true about BPDU port-guard and BPDU filtering?()
Which two statements about the various implementations of STP are true?()
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result?()