Refer to the exhibit.
Which statement is true about where trust boundaries should be established in a network?()
A.Endpoints 2 and 3 are optimal places to establish a trust boundary. Endpoint 1 is an acceptable place to establish a trust boundary.
B.Endpoint 2 is the optimal place to establish a trust boundary. Endpoints 1 and 3 are acceptable places to establish a trust boundary.
C.Endpoint 2 is the only acceptable place to establish a trust boundary.
D.Endpoint 1 is the only acceptable place to establish a trust boundary.
E.Endpoints 1 and 2 are optimal places to establish a trust boundary. Endpoint 3 is an acceptable place to establish a trust boundary.
F.Endpoint 1 is the optimal place to establish a trust boundary. Endpoints 2 and 3 are acceptable places to establish a trust boundary.
您可能感興趣的試卷
你可能感興趣的試題
You need to configure a new Company Catalyst 3560 switch for a VOIP-enabled office.
Which three statements are true about the voice VLAN feature on this switch?()
A.The default CoS value for incoming traffic is set up to 0.
B.The CoS value is trusted for 802.1p or 802.1q tagged traffic.
C.PortFast is automatically disabled when a voice VLAN is configured.
D.The voice VLAN feature is disabled by default.
E.The IP phone accepts the priority of all tagged and untagged traffic and sets the CoS value to 4.
F.When the voice VLAN feature is enabled, all untagged traffic is sent according to the default CoS priority of the port
Refer to the exhibit. Which statement is true about a voice VLAN?()
A.Physically the voice network and the data network are separate.
B.The voice traffic will normally be on a different IP subnet than will the data traffic.
C.End user intervention is necessary to place the phone into the proper VLAN.
D.The same security policy should be implemented for both voice and data traffic.
E.The data VLAN must be configured as the native VLAN.
A.TCP retransmits
B.UDP priority
C.Bursty
D.Delay sensitive
E.Greedy
F.Drop sensitive
Refer to the exhibit.
What are three of the basic components of a VoIP network?()
A.software voice applications
B.multipoint control unit (MCU)
C.gatekeeper
D.call agent
E.interactive voice response (IVR) systems
F.softphones
A.The use of a queuing method that will give VoIP traffic strict priority over other traffic
B.The use of RTP header compression for the VoIP traffic.
C.The proper classification and marking of the traffic as close to the source as possible
D.The use of 802.1QinQ trunking for VoIP traffic
E.The use of WRED for the VoIP traffic
最新試題
During routine maintenance, it became necessary to shutdown G1/0/1 on DS1 and DS2. All other interface were up. During this time, DS1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. What can be done to make the group function properly ? ()
How are STP timers and state transitions affected when a topology change occurs in an STP environment?()
If G1/0/1 on DS1 is shutdown, what will be the current priority value of the Vlan105’s group on DS1 ?()
DS2 has not become the active device for Vlan103’s HSRP group even though all interfaces are active. As related to Vlan103’s HSRP group. What can be done to make the group function properly ? ()
Which three statements are true of the Link Aggregation Control Protocol (LACP)?()
Refer to the exhibit. On the basis of the output of the show spanning-tree inconsistentports command, which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true?()
Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port:00:06:34: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/5 (not half duplex), with SW_A FastEthernet0/4 (half duplex) , with TBA05071417(Cat6K-B) 0/4 (half duplex). What would be the possible outcome of the problem?()
Which statement is correct about the use of the virtual interface on a WLC ?()
Which two statements are true about BPDU port-guard and BPDU filtering?()
Refer to the exhibit. Switch 15 is configured as the root switch for VLAN 10 but not for VLAN 20. If the STP configuration is correct, what will be true about Switch 15?()