A.TCP retransmits
B.UDP priority
C.Bursty
D.Delay sensitive
E.Greedy
F.Drop sensitive
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit.
What are three of the basic components of a VoIP network？（）
A.software voice applications
B.multipoint control unit （MCU）
C.gatekeeper
D.call agent
E.interactive voice response （IVR） systems
F.softphones
A.The use of a queuing method that will give VoIP traffic strict priority over other traffic
B.The use of RTP header compression for the VoIP traffic.
C.The proper classification and marking of the traffic as close to the source as possible
D.The use of 802.1QinQ trunking for VoIP traffic
E.The use of WRED for the VoIP traffic
You need to troubleshoot some problems in the Company VOIP network associated with jitter.
What is the cause of jitter？ （）
A. Packet drops
B. Transmitting too many small packets
C. Variable queue delays
D. Compression
E. None of the other alternatives apply
The Lightweight Access Point Protocol （LWAPP） is in use within the Company wireless network.
Which two statements correctly describe features of this protocol？ （）
A. Control traffic between an access point and a controller is encrypted within LWAPP.
B. Data traffic between an access point and a controller is encrypted within LWAPP.
C. Layer 3 mode packets are transmitted in TCP frames.
D. Data traffic between an access point and a controller is encapsulated within LWAPP.
E. VLAN tagging and QoS markings are applied at the access point.
Which statement about the Lightweight Access Point Protocol （LWAPP） is true？ （）
A. LWAPP encrypts both control traffic and user data.
B. LWAPP encrypts user traffic with an x.509 certificate using AES-CCMP.
C. When set to Layer 3， LWAPP uses a proprietary protocol to communicate with the Cisco Aironet APs.
D. LWAPP encrypts control traffic between the AP and the controller.
E. None of the other alternatives apply.
最新試題
Based on the show spanning-tree vlan 200 output shown in the exhibit， which two statements about the STP process for VLAN 200 are true？ （）
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2？（）
Which statement is correct about the use of the virtual interface on a WLC ？（）
Refer to the exhibit. STP has been implemented in the network. Switch SW_A is the root switch for the default VLAN. To reduce the broadcast domain， the network administrator decides to split users on the network into VLAN 2 and VLAN 10. The administrator issues the command spanning-tree vlan 2 root primary on switch SW_A. What will happen as a result of this change？（）
DS2 has not become the active device for Vlan103’s HSRP group even though all interfaces are active. As related to Vlan103’s HSRP group. What can be done to make the group function properly ？ （）
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals？（）
Which two statements are true about BPDU port-guard and BPDU filtering？（）
Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge.Which switch should theadministrator configure as the root bridge and which configuration command must theadministrator enter to accomplish this？（）
Refer to the exhibit. Switch 15 is configured as the root switch for VLAN 10 but not for VLAN 20. If the STP configuration is correct， what will be true about Switch 15？（）
Refer to the exhibit. Initially， LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements are true about the possible result of attaching the second link？（）