A.Ping 10.1.1.1 Data Pattern M
B.Ping 10.1.1.1 timeout 0
C.Ping 10.1.1.1 size 1500 df-bit
D.Ping 10.1.1.1 source loopback 0
E.Ping 10.1.1.1 size 1500
F.Ping 10.1.1.1 size 1500 Strict
您可能感興趣的試卷
你可能感興趣的試題
A.RIP route 10.1.2.0/24
B.EIGRP route 10.1.2.0/24
C.RIP route 10.1.0.0/16
D.OSPF route 10.1.0.0/16
E.RIP route 10.0.0.0/16
F.OSPF route 10.1.2.0/24
A.OSPF topology table
B.OSPF interface table
C.OSPF routing information base
D.OSPF link-state database
E.OSPF adjacency table
F.OSPF neighbor table
A.Problem report
B.Problem collaboration
C.Problem diagnosis
D.Problem resolution
E.Problem documentation
F.Probiem authentication
A.0000.0c70.ac22
B.0000.0c07.22ac
C.0000.0c07.acl6
D.0000.0c07.ac22
E.0000.0c70.cala
F.0000.0d22.ac07
A.Eliminate potential causes
B.Collect information
C.Document causes
D.Hypothesize underlying causes
E.Verif/ hypothesis
F.Examine collected information
最新試題
Which statement about PPPoA configuration is correct?()
Router NetworkTut is configured as shown below:Given the above configuration, which statement is true?()
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec, which two parameters are required when defining the tunnel interfaceinformation?()
Drag the IPsec protocol description from the above to the correct protocol type on the below.(Notall descriptions will be used)Drag and Drop question, drag each item to its proper location.
As a network engineer, study the exhibit carefully. Router Net is unable to establish an ADSLconnection with its provider. Which action would correct this problem?()
Drag the DSL local loop topic on the left to the correct descriptions on the right.
Drag and drop the xDSL type on the above to the appropriate xDSL description on the below.
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password?()
Drag and drop each management protocol on the above to the correct category on the below.
Network Topology Exhibit:Configuration Exhibit:NET(config)# access-list 112 deny icmp any any echo logNET(config)# access-list 112 deny imp any any redirect logNET(config)# access-list 112 deny icmp any any mask-request logNET(config)# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET(config)# interface Fa0/1NET(config-if)# ip access-group 112 inYou work as a network administrator at networkTut.com, study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However, the configurationis incorrect. On the basis of the information in the exhibit, which configuration option wouldcorrectly configure router NET?()