Refer to the show interface Gi0/1 switchport command output shown in the exhibit. Which twostatements are true about this interface？（）
A.This interface is a member of a voice VLAN
B.This interface is a dot1q trunk passing all configured VLANs
C.This interface is a member of VLAN7
D.This interface is configured for access mode
E.This interface is a member of VLAN1
您可能感興趣的試卷
你可能感興趣的試題
A.show spantree backbonefast
B.show spantree statistics
C.show spantree uplinkfast
D.show spantree blockedports
E.show spantree portstate
F.show spantree portvlancost
The network is displayed in the diagram below：
You use the following information for switch SWA：
Port Mode Encapsulation Status Native VLAN
fa0/1 desirable n-802.1q trunking 5
Port VLANs is allowed on trunk
fa0/ 1 1-100， 102-1005
Port VLANs is owned and active in management domain
fa0/1 1-6. 8-100， 102-115， 197-999， 1002-1005
Port VLANs in spanning tree forwarding state and not pruned
fa0/1 1-6， 8-100， 102-105， 108-999， 1002-1005
SW users in VLAN 107 complain that they are unable to gain access to the resources through theSW1 router.
What is the cause of this problem？（）
A.VLAN 107 is not configured on the trunk
B.VLAN 107 does not exist on switch SWA
C.VTP is pruning VLAN 107
D.Spanning tree is not enabled on VLAN 107
E.None of the other alternatives apply
A.Combine all the VLAN spanning trees into a single spanning tree
B.Set forward delay and max-age timers to the maximum possible values
C.None of the choices
D.Change the router VTP server mode
E.Disable the root bridge
Exhibit
SW1#show spanning-tree vlan 200
VLAN200
Spanning tree enabled protocol iee
eRoot ID Priority 32968
Address 000c.ce29.ef00
Cost 19
Port 2 （FastEthernet0/2）
Hello time 10 Sec Max Age 20 sec Forward Delay 30 sec
Bridge ID Priority 32968 （priority 32768 sys-id-ext 200）
Address 000c.ce2a.4180
Hello Time 2 sec Max Age 20 Sec Forward Delay 15 sec
Interface Role Sts Cost PrioNbr Type
Fa0/2 Root FWD 19 128.2 P2p
Fa0/3 Altn BLK 19 128.3 P2p
Based on the show spanning-tree vlan 200 output shown in the exhibit， which two statementsabout the STP process for VLAN 200 are true？（）
A.BDPUs will be sent out every two seconds
B.The time spent in the listening state will be 30 seconds
C.The time spent in the learning state will be 15 seconds
D.The maximum length of time that the BPDU information will be saved is 30 seconds
E.This switch is the root bridge for VLAN 200
F.BPDUs will be sent out every 10 seconds
A.hello timer
B.BPDU timer
C.Forward_delay timer
D.Max_age timer
E.Dead timer
F.Wait timer
最新試題
In computer security， AAA stands for authentication， authorization and accounting. Which optionabout the AAA authentication enable default group radius enable command is correct？（）
Authentication is the process of determining if a user or identity is who they claim to be. Refer tothe exhibit. Which statement about the authentication process is correct？（）
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed？（）
Drag the correct statements about MPLS-based VPN on the left to the boxes on the right.（Not allstatements will be used）
Drag and drop each management protocol on the above to the correct category on the below.
Router NetworkTut is configured as shown below：Given the above configuration， which statement is true？（）
Drag each element of the Cisco IOS Firewall Feature Set from the above and drop onto itsdescription on the below.
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）