A. NCP
B. LCP
C. ISDN
D. DLCI
E. SLIP
您可能感興趣的試卷
你可能感興趣的試題
A. 10.188.31.0/27
B. 10.188.31.0/26
C. 10.188.31.0/29
D. 10.188.31.0/28
E. 10.188.31.0/25
A. Configure the switch to be in VTP client mode.
B. Configure the switch to be in VTP domaint mode.
C. Configure the switch to be in VTP transparent mode.
D. Configure the switch to be in VTPv2.
A. proxy.
B. dual-stack
C. tunneling
D. dot1q
A. user EXEC mode
B. global configuration mode
C. privileged EXEC mode
D. auxiliary setup mode
A. when a packet is received from an 802.1Q trunk,the vlan id can be determined from the source MAC address table.
B. unkown unicast frames are retransmitted only to the ports that belong to the same vlan
C. ports between switches should be configured in access mode so that vlans can span across the ports
D. broadcast and multicast frames are retransmitted to ports that are configured on different vlan.
最新試題
How are VTP advertisements delivered to switches across the network?()
What is the default administrative distance of OSPF?()
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?()
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?()
An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?()
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?()
What is the purpose of the cisco Vlan Trunking protocol?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()