A. Configure the switch to be in VTP client mode.
B. Configure the switch to be in VTP domaint mode.
C. Configure the switch to be in VTP transparent mode.
D. Configure the switch to be in VTPv2.
您可能感興趣的試卷
你可能感興趣的試題
A. proxy.
B. dual-stack
C. tunneling
D. dot1q
A. user EXEC mode
B. global configuration mode
C. privileged EXEC mode
D. auxiliary setup mode
A. when a packet is received from an 802.1Q trunk,the vlan id can be determined from the source MAC address table.
B. unkown unicast frames are retransmitted only to the ports that belong to the same vlan
C. ports between switches should be configured in access mode so that vlans can span across the ports
D. broadcast and multicast frames are retransmitted to ports that are configured on different vlan.
A. an OSPF update for network 192.168.0.0/16
B. a static router to network 192.168.10.0/24
C. a static router to network 192.168.10.0/24 with a local serial interface configured as the next hop
D. a RIP update for network 192.168.10.0/24
E. a directly connected interface with an address of 192.168.10.254/24
F. a default route with a next hop address of 192.168.10.1
A. session
B. network
C. physical
D. data link
E. transport
最新試題
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?（）
Three access ports have been installed and configured to a small office.What term defines the wireless topology?（）
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
On which options are standard access list based?（）
Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?（）
An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?（）
Which statement describes the rule of split horizon?（）
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?（）