A. RIPng allows for routes with up to 30 hops.
B. RIPng is enabled on each interface separately.
C. RIPng uses broadcasts to exchange routes.
D. There can be only one RIPng process per router.
您可能感興趣的試卷
你可能感興趣的試題
A. tunneling
B. hashing
C. routing
D. NAT
A. NIC
B. BIA
C. OUI
D. VAI
A. Connect a router on a local network.
B. Connect a router to another router.
C. Allow distribution of routes between networks.
D. Translate a private IP address.
E. Connect a network to the Internet.
A. Addresses in a private range will be not routed on the Internet backbone.
B. Only the ISP router will have the capability to access the public network.
C. The NAT process will be used to translate this address in a valid IP address.
D. Several automated methods will be necessary on the private network.
E. A conflict of IP addresses happens, because other public routers can use the same range.
A. 10.180.48.224
B. 9.255.255.10
C. 192.168.20.223
D. 172.16.200.18
最新試題
On which options are standard access list based?（）
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?（）
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
What is the subnetwork address for a host with the IP address 201.100.5.68/28?（）
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?（）
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?（）
At which layer of the OSI model is RSTP used to prevent loops?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
Which command displays the CHAP authentication process as it occurs between two routers?（）