A. Replace the straight-through cable with a crossover cable.
B. Change the subnet mask of the hosts to /25.
C. Change the subnet mask of the hosts to /26.
D. Change the address of Workstation A to 192.0.2.15.
E. Change the address of Workstation B to 192.0.2.111.
您可能感興趣的試卷
你可能感興趣的試題
A.113.10.4.0
B.186.54.3.0
C.175.33.3.255
D.26.35.2.255
E.17.35.36.0
A.192.168.5.55
B.192.168.5.47
C.192.168.5.40
D.192.168.5.32
E.192.168.5.14
A.802.1Q giants frames could saturate the link.
B.VLAN10 on CAT1 and VLAN1 on CAT2 will send untagged frames.
C.A native VLAN mismatch error message will appear.
D.VLAN10 on CAT1 and VLAN1 on CAT2 will send tagged frames.
A.show configuration
B.show environment
C.show inventory
D.show platform
E.show version
A.%
B.@
C.>
D.$
E.#
最新試題
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()
At which layer of the OSI model dose PPP perform?()
On which options are standard access list based?()
What is the subnetwork address for a host with the IP address 201.100.5.68/28?()
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
Which statement describes the rule of split horizon?()
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?()