A.00000
B.12345
C.23456
D.65000
E.99999
您可能感興趣的試卷
你可能感興趣的試題
A. The Layer 2 multicast address of the destination node
B. The solicited node multicast address of the destination node
C. The Layer 2 address of the destination node based on the destination IPv6 address
D. The IPv6 address of the destination node based on the destination Layer 2 address
A.6to4
B.6over4
C.ISATAP
D.GRE
A.0.0.0.1
B.0.255.0.1
C.2001:DB8::1
D.2001:DB8:ABCD:FEEF::1
A.2001:DB8::1 and 2001:DB8::2
B.2001:DB8::9 and 2001:DB8::10
C.2001:DB8::10 and 2001:DB8::17
D.2001:DB8::1 and 2001:DB8::18
A.The autoconfig command is missing from the router interface.
B.IPv6 multicast routing is not enabled on the router interface.
C.IPv6 unicast routing is not enabled on the router interface.
D.The router interface is configured with a /63 mask.
E.The router interface is configured with a /65 mask.
最新試題
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router?()
An expanding company is deploying leased lines between its main site and two remote sites. Thebandwidth of the leased lines is 128kb/s each,terminated on different serial interfaces on the main router.These links are used for combined VOIP and data traffic. The network administrator has implemented a VOIP solution to reduce costs,and has therefore reserved sufficient bandwidth in a low latency queue oneach interface for the VOIP traffic. Users now complain about bad voice quality although no drops areobserved in the low latency queue. What action will likely fix this problem?()
In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicasttraffic to a group?()
You are the network administrator of an enterprise with a main site and multiple remote sites. Your networkcarries both VOIP and data traffic. You agree with your service provider to classify VOIP and data trafficaccording to the different service RFCs. How can your data and VOIP traffic be marked?()
In order to configure two routers as anycast RPs, which of these requirements, af a minimum, must besatisfied?()
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link,but only allow eachindividual flow to use 1 MB/s?()
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree ProtocolIEEE 802.1 D?()
In Layer 2 topologies, spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions?()
What is the correct command to set the router ID for an OSPFv3 process?()
All of these are fundamental building blocks of differentiated services Traffic Conditioner Block exceptwhich one?()