單項選擇題what is the cause of this problem?（）

A.The OSPF area is not configured properly.
B.The priority on R1 should be set higher.
C.The cost on R1 should be set higher.
D.The hello and dead timers are not configured properly.
E.A backup designated router needs to be added to the network.
F.The OSPF process ID numbers must match.


您可能感興趣的試卷

你可能感興趣的試題

3.多項選擇題Which three IP addresses can be assigned to hosts if the subnet mask is /27 and subnet zero is usable？（）

A. 10.15.32.17
B. 17.15.66.128
C. 66.55.128.1
D. 135.1.64.34
E. 129.33.192.192
F. 192.168.5.63

4.多項選擇題The network administrator has been asked to give reasons for moving from ipv4 to ipv6. what are two validreasons for adopting ipv6 over ipv4？（）

A.telnet access does not require a password
B.nat
C.no broadcast
D.chanage of destination address in the ipv6 header
E.chanage of source address in the ipv6 header
F.autoconfiguration

5.單項選擇題The network administrator has discovered that the power supply has failed on a switch in the company LAN and that the switch has stopped functioning. It has been replaced with a Cisco Catalyst 2950 series switch. What must be done to ensure that this new switch becomes the root bridge on the network？（）

A. Lower the bridge priority number.
B. Change the MAC address of the switch.
C. Increase the VTP revision number for the domain.
D. Lower the root path cost on the switch ports.
E. Assign the switch an IP address with the lowest value.