A. amplifier
B. attenuator
C. regenerator
D. light emitter
E. optical switch
F. optical receiver
G. fiber-optic cable
您可能感興趣的試卷
你可能感興趣的試題
A. fiber loss
B. OSNR level
C. post amplification
D. index of reflection
E. index of refraction
F. power post amplification budget
A. low optical power
B. high optical power
C. few optical channels
D. many optical channels
E. low chromatic dispersion
F. high chromatic dispersion
G. too much power differential in the optical channels
A. They are both regions of lowest loss.
B. They are both regions of low reflections.
C. They are both regions of low index of refraction.
D. They are both regions of low chromatic dispersion.
E. They are both regions of low Polarization Mode Dispersion (PMD).
A. lower cost
B. higher chirp
C. easier to manufacture
D. higher dispersion tolerance
E. higher optical signal-to-noise ratio
A. OSNR
B. dispersion
C. attenuation
D. power budget
E. amplifier spacing
F. four wave mixing
最新試題
SONET Path Terminating Equipment (PTE) requires which three line codes to be supported for DS1 and DS3 circuits?（） (Choose three.)
What is an advantage of an externally modulated laser over a directly modulated laser?（）
What is the difference between the transmitted power and the sensitivity of the receiver?（）
If node 2 is accepting line timing from node 1, node 2 will send （）to node 1 as its SSM message.
A Channel ID mismatch occurs when （）.
Which three technologies are used to reduce chromatic dispersion accumulation in fiber-optic transmission systems? （）(Choose three.)
Which timing mode is appropriate for a SONET NE that is adjacent to a SONET NE using BITS-1 timing source?（）
How is a Thin Film filter fabricated?（）
How is UPSR and BLSR traffic rerouted during a protection switch when a complete fiber cable cut occurs?（）
For lasers with tightly controlled wavelengths, approximately how far apart are the centers of adjacent wavelengths when 100 GHz spacing is used in a DWDM system?（）