During the installation of the Cisco WCS， an error occurs.
Where will the installation log be found？（）
A.at the root of the installation drive
B.in the Cisco WCS installation directory
C.on the desktop of the server
D.in the Cisco WCS\Logs directory
您可能感興趣的試卷
你可能感興趣的試題
A lightweight access point has been connected to a Catalyst 3550 24-PWR switch， and on power-up the access point fails.
What is the problem with the switch？（）
A.The power supply has inadequate wattage.
B.Power is incorrectly configured on the port.
C.It does not support 802.3af Poe.
D.Power is not enabled on the port.
Two access points running the core feature set are connected to the same switch and are providingguest services.
If PSPF is enabled， what must be enabled on the switch to prevent clients fromseeing one another’s data？（）
A.port-based RADIUS
B.802.1q trunking
C.inline power
D.protected port
A.startup
B.site survey mode
C.lost connection to the controller
D.duplicate IP address
Last December you erected a bridge link between two buildings on your campus. It is now Apriland the foliage in the trees is full， and the bridge link will no longer maintain connectivity.
Which action will most likely solve the problem？（）
A.Change the channel selection.
B.Install higher gain antennas.
C.Raise the antennas.
D.Increase transmitter power.
An 802.1X client cannot authenticate to an autonomous access point configured for multiple
VLANs. The native VLAN does not have an SSID configured.
Which one of the following links being down would prevent the clients from authenticating？（）
A.between the RADIUS and the access point
B.between the client’s VLAN and the WLSE
C.between the native VLAN and the WLSE
D.between the client’s VLAN and the RADIUS
最新試題
Which protocol does the RADIUS server use inside the secure tunnel of EAP-FAST to authenticatethe client when one-time passwords are in use？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
The Cisco Wireless Location Appliance provides an audit trail for each device tracked for up to how many days？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.What is the maximum number of WLAN controllers that you can add？（）
You are using ADU and are authenticated and associated to an access point. However， you are unable to obtain an IP address.Which of these has caused this problem？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem？（）
Clients using Cisco-LEAP and EAP-FAST authentication are having no problems logging on to thewireless network， but clients using PEAP are failing to log on.Which situation would result in thistype of problem？（）