A. Shared
B. Point-to-Point
C. Designated
D. Multiaccess non-broadcast
您可能感興趣的試卷
你可能感興趣的試題
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.
Enabling which of the following feature will be able to prevent this problem from happening again?（）
A.GLBP
B.RSTP
C.BPDU guard
D.root guard
A. Disables the interfaces to prevent traffic flow
B. Clears all the configurations on the interface
C. Switches the port from access mode to trunk mode
D. Converts the port from physical Layer 2 port to physical Layer 3 port
A.9
B.3
C.12
D.6
A. using DHCP snooping
B. snooping the incoming 802.1Q VLAN tag
C. using CDP
D. snooping the CoS marking on the incoming frames
A. Route reflectors are not passing updates properly.
B. BGP synchronization has been enabled.
C. The next-hop address is unreachable.
D. No loopback interface has been configured on a router.
最新試題
With a VPN Accelerator Module 2+ (VAM2+) installed in a Cisco 7200 series router, what will be the resulting action when entering the command no crypto engine accelerator slot number?（）
When a Cisco router is configured for SSH, it acts as an （）?
Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? （）(Choose two.)
Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?（）
You are trying to initiate an SSH connection to a remote router and are getting rejected with an error code of 0. Which of these might be the cause of the error?（）
You are an experienced network administrator in an international corporation. One of your clients asks you to configure a network for a financial trading center which requires multiple high-value transactions.And the transactions are very important to the client. In such a situation, which two of the following are basic and most important requirements concerning the configuration? （）(Choose two.)
What are four advantages to using tunnel brokers in an IPv6 transition environment?（）
Which of the following allows network administrators to easily apply common services and employ features across Cisco switches, routers, and access points with an intuitive GUI?（）
In a high-availability network, which command, when placed on ports that have connected end stations, will allow you to prevent delays in service for end stations by placing a port in blocking mode?（）
Refer to the exhibit. Which two of these events will be the result of issuing the above command? （）(Choose two.)