A.Systems Integration
B.Skill Assessment
C.Systems Acceptance Testing
D.Wireless Check
E.Project Close Out
您可能感興趣的試卷
你可能感興趣的試題
When optimizing a standalone point-to-multipoint bridge installation with eight non-root bridges.
Which of the following RTS threshold and CWmin settings would be correct for the non-root bridges？（）
A.RTS threshold = 1，CWmin = 4
B.RTS threshold = 4000，CWmin = 5
C.RTS threshold = 4000，CWmin = 3
D.RTS threshold = 1，CWmin = 5
You review the Failed Attempts logs on an AAA server and find： "unknown network access servererror."
Which failure could produce this error？（）
A.AAA client and AAA server handshake failure
B.supplicant authentication failure
C.wrong password used by the supplicant
D.failure of the wireless client and AAA server handshake
During the installation of the Cisco WCS version 4.0， an error occurs.
Where would you look forthe installation log，in order to learn more about this error？（）
A.at the root of the installation drive
B.in the Cisco WCS installation directory
C.on the desktop of the server
D.in the Cisco WCS\Logs directory
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.
What is the maximum number of WLAN controllers that you can add？（）
A.17
B.20
C.12
D.24
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones.
Whichtwo general control settings should you select？（）
A.Multicast on
B.Aggressive Load Balancing off
C.Multicast off
D.AP Fallback on
E.Aggressive Load Balancing on
最新試題
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it， which continue to pass traffic.What has causedthis problem？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to？（）
Which protocol does the RADIUS server use inside the secure tunnel of EAP-FAST to authenticatethe client when one-time passwords are in use？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
On a WLAN controller， what is the default roaming bandwidth percentage reserved for voice clients？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）