You are installing a cisco 4402 series wireless lan controller.
What type of interface is used on the uplink port?()
A.1000base-x mini-gbic
B.10/100/1000 mbps rj45
C.10/100 mbps rj45
D.1000base-sx
您可能感興趣的試卷
你可能感興趣的試題
A.interference,utilization,and rf diffraction
B.clients,utilization,and multipath interference
C.noise,interference,and coverage holes
D.noise interference,and multipath interference
Static wep is configured on the access point. you are authenticated and associated to the access point but are unable to obtain an ip address.
Which of the following will cause this problem?()
A.invalid radio type selected
B.no wep key configured on the client
C.invalid ssid configured
D.invalid wep key
An reap was supporting 16 wlans, but now it only supports one.
What happened to cause the change?()
A.controller connectivity has been lost.
B.the access point lost its configuration.
C.the access point was rebooted.
D.an access point firmware upgrade is in progress.
A rogue access point is detected on the cisco wcs consolE. upon investigation,the access point is discovered to belong to a neighboring business.
Your administrator should designate the rogue access point as which of the following?()
A.known internal
B.managed
C.friendly
D.known external
A.30 mw
B.100 mw
C.40 mw
D.50 mw
最新試題
You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem?()
The Cisco Wireless Location Appliance provides an audit trail for each device tracked for up to how many days?()
You are trying to change the polling parameters used by the location manager via the Cisco WCS,and your request is being denied. What is wrong?()
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side,which of the following actionsshould you perform on the wired infrastructure?()
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective?()
When configuring Cisco Secure ACS to support wireless EAP authentication, which device must be configured as a AAA client?()
You review the Failed Attempts logs on an AAA server and find: "unknown network access servererror." Which failure could produce this error?()
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.What is the maximum number of WLAN controllers that you can add?()
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem?()
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS? ()