多項選擇題avoid Layer 2 loops. Which two of the following are most probably the reasons for that preference?()

A. Information about port roles is sent to all switches.
B. RSTPs that are based on Cisco products require no additional configuration.
C. Features such as UplinkFast and BackboneFast are compatible with RSTP.
D. An RSTP that is based on Cisco products generally performs better than the Cisco proprietary 802.1D enhancements.


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題As an experienced Network Engineer, you are responsible for network connectivity and system configuration. Which of the following protocols will be supported by Cisco Nonstop Forwarding (NSF)?()

A.ISSU,OSPF,IS-IS
B.IETF,OSPF,ISSU
C.IS-IS,EIGRP,SSO,BGP
D.EIGRP,BGP,OSPF,IS-IS

2.單項選擇題As a network administrator, you have configured a Catalyst 6500 Series Switch with redundant supervisor engine in a CIS network. What is the result of issuing the redundancy force-switchover command on that switch?()

A. Automatic switchover from active to standby on primary supervisor failure
B. Reset of the primary supervisor.
C. Manual switchover from active to standby supervisor
D. Manual switchover from standby to active supervisor

3.單項選擇題As an experienced technician, you are required to configure and verify SRM with SSO redundancy. In such a situation, you have to issue several commands in proper orders. Which of the following is correct?()

A. show redundancy states, redundancy, mode sso
B. show redundancy states, mode sso, redundancy
C. redundancy, mode sso, show redundancy states
D. mode sso, redundancy, show redundancy states

最新試題

Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?()

題型:單項選擇題

Which command displays only those entries in a BGP table with specific AS_PATH attributes?()

題型:單項選擇題

Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?()

題型:單項選擇題

When a Cisco router is configured for SSH, it acts as an ()?

題型:單項選擇題

Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?()

題型:單項選擇題

You are an experienced network administrator in an international corporation. One of your clients asks you to configure a network for a financial trading center which requires multiple high-value transactions.And the transactions are very important to the client. In such a situation, which two of the following are basic and most important requirements concerning the configuration? ()(Choose two.)

題型:多項選擇題

You are trying to initiate an SSH connection to a remote router and are getting rejected with an error code of 0. Which of these might be the cause of the error?()

題型:單項選擇題

What is the purpose of using VPN hardware acceleration equipment?()

題型:單項選擇題

Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?()

題型:單項選擇題

As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?()

題型:單項選擇題