A.Bluetooth
B.frequency hopping
C.microwave oven
D.802.11b client card
E.802.11b access point
您可能感興趣的試卷
你可能感興趣的試題
A.ISM 2.4 GHz
B.ISM 900 MHz
C.ISM 5 GHz
D.public safety 4.9 GHz
E.GSM 1.9 GHz
A.data/coverage
B.location with Monitor Mode access points
C.demand
D.high density
A.100 mW， 24 Mb/s
B.100 mW， 18 Mb/s
C.25 mW， 18 Mb/s
D.3.2 mW， 54 Mb/s
A.In a multifloor building， the access point layout from the survey of one floor can be directly applied to the remaining floors
B.Access points can be installed in the same place on every floor， without worrying about co-channelinterference
C.You can survey with a Cisco AIR-ANT5959 in a plenum environment
D.Identify all hazardous and restricted areas that might require extra or special survey and installationwork
A.Active mode does not require the client to be specifically confgured
B.Passive mode can survey more than one access point at a time
C.Active mode yields signal-quality information such as packet retries and lost packets
D.Active mode requires more time to survey but yields more information results than passive mode does
最新試題
Which two Cisco antennas provide better isolation from RF sources that might be located behindthe antennas？（）
Which can NOT be selected for supported services in Cisco WCS Planning Tool？（）
When planning for VoWLAN capacity during a site survey， how many simultaneous calls can beestimated per 5 GHz channel？（）
What should be done if Cisco Spectrum Expert Wi-Fi reports a channel utilization of 40 percent onchannel 36， from a source outside of the site？（）
What does a Cisco Unified Wireless IP Phone 7921G deployment require（）？
What does a broad-spectrum interferer lower？（）
Which three colors are used in the Cisco WCS v5.2 Voice Readiness Tool？（）
What is a site survey best practice for location-based services？（）
Given the correct input parameters， the Cisco WCS Planning Tool can calculate a recommendedaccess point count for which three uses？ （）
For an active Cisco Unified Wireless IP Phone 7921G 5 GHz site survey， what are the mostappropriate client test settings to use with the AirMagnet site survey tool？（）