You are troubleshooting a one-way call problem with a cisco 7920 wireless ip phone on a standalone wlan.
What may have caused this problem？（）
A.the minimum data rate is not set to 11 mbps.
B.publicly secure packet forwarding is enabled.
C.the access point is set to the least congested channel.
D.an address resolution protocol has been disabled.
您可能感興趣的試卷
你可能感興趣的試題
A.operations plan
B.operations assessment
C.security administration
D.system monitoring
E.operations implementation
F.incident management
A.ciscoaironet 1400 series
B.ciscoaironet 1300 series
C.ciscoaironet 1100 series
D.ciscoaironet 1240ag series
On a cisco aironet 1130ag series standalone access point,the status led is dark blue and blinking.
What does this indicate？（）
A.the internal radio has failed.
B.a firmware upgrade is in progress.
C.an access point buffer overflow is occurring.
D.the access point is booting.
In a deployment using standalone access points， clients set up to authenticate with eap-peap or eap-cisco wireless （cisco-leap） cannot authenticatE. when you inspect the failed attempts report on the cisco secure acs， you find this error： "unknown network access server nas."
Which problem may have caused this failure？（）
A.misconfigured ip address of the aaa server on the access point
B.misconfigured eap type on the access point
C.misconfigured ip address of the access point on the aaa server
D.misconfigured eap type on the aaa server
A.router （config-ssid）# guest-mode
B.router （config-ssid）# advertise
C.router （config-ssid）# enable
D.router （config-ssid）# broadcast
最新試題
You are using ADU and are authenticated and associated to an access point. However， you are unable to obtain an IP address.Which of these has caused this problem？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor，4GB RAM， and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem？（）
What is the maximum number of wireless controllers that the highest-end Cisco WCS server canmanage？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
On a Cisco Aironet 1240AG Series standalone access point， the radio LED is dark blue and blinking，but the status LED and Ethernet LED are both off.What does this indicate？（）
You review the Failed Attempts logs on an AAA server and find： "unknown network access servererror." Which failure could produce this error？（）
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）