A.OSPF
B.RIP
C.RPF
D.BGP
E.EIGRP
您可能感興趣的試卷
你可能感興趣的試題
A.background
B.best effort
C.voice
D.video
A.Platinum
B.Gold
C.Silver
D.Bronze
A.A packet is delivered to Cisco WLC and forwarded via multicast to all of its associated APs, and finally to all wireless clients of that Cisco WLC, via wireless multicast.
B.A packet is delivered to Cisco WLC and forwarded via unicast to all of its associated APs, and finally to all wireless clients of that Cisco WLC, via wireless unicast.
C.A packet is delivered to Cisco WLC and forwarded via multicast to all of its associated APs, discarded at APs without SSID_X joined wireless clients, and forwarded at APs with SSID_X joinedwireless clients via wireless multicast.
D.A packet is delivered to Cisco WLC and forwarded via unicast to all of its associated APs, discarded at APs without SSID_X joined wireless clients, and forwarded at APs with SSID_X joined wireless clients via wireless multicast.
E.A packet is delivered to Cisco WLC and forwarded via multicast to all of its associated APs, discarded at APs without SSID_X joined wireless clients, and forwarded at APs with SSID_X joinedwireless clients via wireless unicast.
F.A packet is delivered to Cisco WLC and forwarded via unicast to all of its associated APs, discarded at APs without SSID_X joined wireless clients, and forwarded at APs with SSID_X joined wireless clients via wireless unicast.
A.enable aggressive load balancing
B.enable coverage hole detection
C.disable dynamic transmit power control
D.enable short preamble
A.mesh bridge in
B.regular
C.bi-directional bridge
D.in
E.out
A.duplicate sender packets
B.unicast packet retry rate
C.unicast packet retry ratio
D.association rejections
A.disable higher data rates
B.set DTIM = 1
C.disable RRM
D.disable broadcast SSID
E.disable multicast
A.nominally 30 percent to best align with Cisco Unified Communications System recommendations
B.100 percent to ensure that the VoWLAN calls can use all the available bandwidth, if needed
C.system default of 75 percent
D.40 to 60 percent
E.voice CAC should be left disabled unless wired QoS is configured
A.RSSI of the client at the access point
B.WMM state
C.current MOS value
D.current RF channel
E.current transmit data rate
A.synchronization of the transmission and reception of voice frames
B.bandwidth reservation
C.optimized power-save mode periods
D.increased call capacity
E.priority bandwidth and polling
最新試題
What will improve the battery life of a Cisco Unified Wireless IP Phone 7921G?（）
Which three WLC items are required to properly enable queuing with TSPEC for voice traffic?（）
Which statement describes the call behavior of the Cisco Unified Wireless IP Phone 7921G when it roams from 802.11b to 802.11a?（）
Which two EAP types does the Cisco Unified Wireless IP Phone 7921G firmware code version 1.3(x) support?（）
Which three statements are true about load-based Call Admission Control?（）
What is the recommended Cisco DSCP value for a switch or router passing Cisco Unified Wireless IP Phone 7921G RTP packets?（）
What is the bandwidth requirement of an active duplex wireless call using G.711 codec?（）
An LWAPP encapsulated packet is being sent from the Cisco WLC v5.2 to the AP for a wireless WMM client. Can the LWAPP frame be altered to change the resulting final WMM queue for transmission on an 802.11 client?（）
Which two pieces of information does the Cisco WLC v5.2 client monitor feature provide about a VoWLAN client?（）
Which three solutions does AirMagnet VoFi Pro Analyzer integrate?（）