Refer to the exhibit. On the basis of the output, what two conclusions can be reached?（）
A. The default administrative distance has been changed.
B. IS - IS is not enabled.
C. Three physical interfaces are taking part in integrated IS - IS.
D. IS - IS is not redistributing any oth er routing protocols.
E. There are two neighboring routers sending IS - IS routing information.
F. Address summarization is configured.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. What three statements are true about the IS - IS configuration?（）
A.The router is in area 49.0001.0002
B.The router acts as a Level 1 - 2 router
C.CLNS routing is enable d for the router
D.The router has a system ID of 0003.0004
E.The interfaces have a functional IS - IS configuration
F.The network service access point selector (NSEL) byte has a value of 0
Refer to the exhibit. This network is running IS - IS. Router RTC is inside Cloud#1. From the output on RTD, which two statement s are true?（）
A.Because it is running IS - IS in IP - only mode, RTD will not transmit CLNS packets
B.IP routing updates between RTC and RTD will be IP datagrams that are encapsulated by HDLC
C.The SNPA for RTE is the source data link address that is used to transmit frames to RTD
D.IP routing updates between RTC and RTD will be CLNS datagrams that are encapsulated by HDLC
E.The NET for RTE will be 49.0150.0019.06b7.fd5f.00
F.IP routing updates between RTC and RTD will be IP datagrams that a re encapsulated by CLNS
Refer to the exhibit. Router R1 is being used as a relay device for autoconfiguration of switch S1.Which configuration will acc omplish this? （）
A.S1(config)# interface fastethernet 0/1 S1(config - if)# ip helper - address 10.0.0.2
B.S1(config)# interface fastethernet 0/1 S1(config - if)# ip helper - address 20.0.0.1
C.R1(config)# interface fastethernet 0/0 R1(config - if)# ip help er - address 20.0.0.2R 1(config - if)# ip helper - address 20.0.0.3 R1(config - if)# ip helper - address 20.0.0.4 R1(config - if)# exit R1(config)# interface fastethernet 0/1 R1(config - if)# ip helper - address 10.0.0.1
D.R1(config)# interface fastethernet 0/0 R1 (config - if)# ip helper - address 20.0.0.1 R2(config)# interface fastethernet 0/0 R2(config - if)# ip helper - address 20.0.0.1 R3(config)# interface fastethernet 0/0 R3(config - if)# ip helper - address 20.0.0.1 R4(config)# interface fastethernet 0/0 R4(config - if)# ip helper - address 20.0.0.1
E.S1(config)# interface fastethernet 0/1 S1(config - if)# ip helper - address 10.0.0.2 R2(config)# interface fastethernet 0/0 R2(config - if)# ip helper - address 20.0.0.1 R3(config)# interface fastethernet 0/0 R3(config - if) # ip helper - address 20.0.0.1 R4(config)# interface fastethernet 0/0 R4(config - if)# ip helper - address 20.0.0.1
A. If a packet is sent to a multicast group address, the multicast frame contains the source multicast address.
B. A router does not have to be a member of a multicast group to recei ve multicast data.
C. A router must be a member of a multicast group to send to the group.
D. A router does not have to be a member of a multicast group to send to the group.
E. If a packet is sent to a multicast group address, all members of the multic ast group will receive it.
F. A router must be a member of a multicast group to receive multicast data.
A.Multicast addresses 224.0.0.13 and 224.0.0.22 are reserved link - local addresses used by PIMv2 and IGMPv3
B.Because they would map to overlapping IP multicast MAC addresses, multicast addresses 224.0.1.1 and 238.1.1.1 could not be used toget her
C.Multicast addresses 224.0.0.0 through 224.0.0.255 are always forwarded because they are transmitted with Time to Live (TTL) greater than 1
D.Multicast addresses 224.0.0.5 and 224.0.0.6 are source multicast addresses for OSPF routers
E.The a dministratively scoped multicast addresses 239.0.0.0 through 239.255.255.255 are similar in purpose to RFC 1918 private unicast addresses
F.Multicast address 224.0.1.1 has been reserved for the Network Time Protocol (NTP) by the IANA
最新試題
Which of the following is helpful to allow an IPv6 host to learn the IP address of a default gateway on its subnet?（）
The following configuration exists on a router on one end of an IPv6 tunnel. Although the configuration added so far is correct, the configuration is incomplete. Which type of tunnel is most likely to be intended by the network engineer？（）interface loopback 1ip address 192.168.1.1 255.255.255.255interface tunnel 2ipv6 address 2002:C0A8:10 1::1/64tunnel source loopback 1
Which of the following are true of both OSPFv2 and OSPFv3?（）
Router R1 has the following configuration. Assuming R1's F0/0 interface has a MAC address of 0200.0011.1111, what IPv6 addresses will R1 list for interface F0/0 in the output of the show ipv6 interface brief command?（）interface f0/0ipv6 address 2345:0:0:8::1/64
An enterprise h as plans to start adding IPv6 support. For the first year, the IPv6 will be in small pockets spread around the existing large IPv4 network, with occasional IPv6 traffic while applications teams test IPv6 - enabled servers and applications.Which of the fol lowing tools would be most appropriate?（）
Router R1 connects to Router R2 over an Ethernet LAN with both routers using their F0/0 interfaces. R1 learns a route from R2 using EIGRP f or IPv6. That route lists F0/0 as the outgoing interface with R2 as the next hop. The configuration excerpt shows all relevant configuration on R2's F0/0 interface. Which of the following is true about R1's route?（）interface f0/0mac - address 1111.1111.1 111ipv6 address 2000::/64 eui - 64ipv6 address 2001::1/64
An enterprise has plans to start adding IPv6 support. The initial deployment requires support from some IPv6 - only device s that need to access servers that support only IPv4.Which of the following tools would be most appropriate?（）
Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, destined for an Enterprise network.Which of the following answers best describes the router's logic that tells the router, for a given packet, to apply GRE encapsulation to the packet?（）
Which of the following features work the same in both RIP- 2 and RIPng?（）
Router R1 sits at an Enterprise branch office, using both the Internet and a leased line to another Enterprise router for its two connectivity options back into the rest of the Enterprise network. The engineer planning for this branch decided to use the leased line for all Enterprise traffic, unless it fails, in which case the Internet connection should be used to pass traffic to the Enterprise.Which of the following is most likely to be useful on the branch router?（）