A. It uses inexpensive hubs
B. It operates without collisions
C. It operates on switches
D. It provides faster data transfer
E. It utilizes fewer wiring pairs
您可能感興趣的試卷
你可能感興趣的試題
A. Full-duplex Ethernet uses CSMA/CD to prevent collisions.
B. Half-duplex Ethernet uses a loopback circuit to detect collisions.
C. A full-duplex Ethernet card allows 20Mbps for data transmission.
D. Full-duplex Ethernet makes use of two pairs of wires for data.
E. An Ethernet hub can operate both half and full duplex simultaneously.
A. The destination host sends a request to the source for retransmission.
B. The jam signal indicates that the collision has been cleared.
C. The hosts will attempt to resume transmission after a time delay has expired.
D. An electrical pulse indicates that the collision has cleared.
E. The router on the segment will signal that the collision has cleared.
F. The hosts will do nothing, as the higher layers are responsible for data error correction and re-transmission.
A. 802.11
B. 802.5
C. 802.3ab
D. 802.3ae
E. 802.3z
F. 802.3u
A. Too many hosts in a broadcast domain
B. Full duplex operation
C. Broadcast storms
D. Multicasting
E. Segmentation
F. Low bandwidth
A. The use of Full-Duplex Mode.
B. The Creation on New Collision Domains.
C. The Creation on New Broadcast Domains.
D. The Addition of Hubs to the Network.
E. The use of switches in the Network.
F. The Amount of ARP or IPX SAP Traffic.
最新試題
New switches have been purchased for a network upgrade. The objective for the network design emphasizes efficient, error-free transport instead of fast transport.Which switching mode should be configured on the new switches to provide error-free transport to the network? （）
A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? （）
The network 172.12.0.0 needs to be divided into subnets where each subnet has the capacity of 458 IP addresses.What would be the correct subnet mask to accomplish this division keeping the number of subnets at the maximum? （）
Which characteristics are representative of a link-state routing protocol?（）
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?（）
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? （）
Which of the following contribute to congestion on an Ethernet network?（）
All WAN links is side the TestKing.com network use PPP with for authentication security. Which command will display the CHAP authentication process as it occurs between two routers in the network?（）
What is the purpose of typing o/r 0x2142 during a password recover procedure on a 2500 series router?（）
Which of the following options lists the steps in PPP session establishment in the correct order?（）