A. ::/0 is the default route, and ::/128 is the unspecified address.
B. ::/0 is the unicast address, and ::/128 is the anycast address.
C. ::/0 is the anycast address, and ::/128 is the multicast address.
D. ::/0 is the unicast address, and ::/12 8 is the multicast address.
E. ::/0 is the unspecified address, and ::/128 is the multicast address.
F. ::/0 is the anycast address, and ::/128 is the default address.
您可能感興趣的試卷
你可能感興趣的試題
A. Every 16 - bit segment segment that consists of all zeroes can be represented with a single colon.
B. The trailing zeroes in any 16 - bit segment do not have to be written.
C. The leading zeroes in any 16 - bit segment do not have to be written.
D. Any single, continuous string of one or more 16 - bit segments that consists of all zeroes can be represented with a double colon.
E. The maximum number of times a double colon can replace a 16 - bit segment that consists of all zeroes is two.
F. Two zeroes in the middle of any 16 -bit segment do not have to be written.
A. The network was originated via redistribution of an interior gateway protocol into BGP.
B. The network was defined by a static route.
C. The network was learned via IBGP.
D. The network was learned via EBGP.
E. The network was originated via a network or aggregate command.
A. Within an AS, all routers must run either BGP or IBGP.
B. An AS uses exterior gatew ay protocols (EGPs) to exchange information with other autonomous systems.
C. An AS is a group of routers under the same technical administration.
D. Within an AS, routes learned through BGP can be redistributed using interior gateway protocols.
E. Wi thin an AS, routes learned through an interior protocol cannot be redistributed using BGP to other autonomous systems.
A. The IBGP neighbor is not directly connected.
B. BGP synchronization is enabled in a transit autonomous system with fully - meshed IBGP neighbors.
C. The EBGP neighbor ebgp - multihop option is set to the de fault value.
D. The BGP update interval is different between the two BGP neighbors.
E. The BGP neighbor is referencing an incorrect autonomous system number in its neighbor statement.
F. There is an access list blocking all TCP traffic between the two BGP neighbors.
A. show ip bgp paths
B. show ip bgp peers
C. show ip bgp
D. show ip bgp summary
最新試題
Which of the following must match for two directly connected routers running OSPF to establish a neighbor adjacency?（）
A client host uses IPv4 to communicate with one ser ver and IPv6 to communicate with another.Which of the following IPv6 coexistence features is likely at work on the host?（）
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exis ts in a planning document intended to be used to copy/paste into Router R1 to enable EIGRP for IPv6 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about EIGRP for IPv6 on R1 after this configuration has been pasted into R1?（）ipv6 router eigrp 1ipv6 unicast- routinginterface f0/0ipv6 address 2000::1/64ipv6 eigrp 1interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 eigrp 1
The answers each list a tunnel method and two consecutive IPv6 address quartets.Which answers identify a tunneling method that relies on an IPv4 address to be embedded into an IPv6 address, within the correct quartets listed?（）
Router R1, a branch router, connects to the Internet using DSL. The engineer plans to use a configuration with a dialer interface. The answers list a feature and interface on which the feature could be configured.Which combinations accurately describe the interface under which a feature will be configured?（）
The following output occurs on Router R1 , which runs both EIGRP for IPv6 and OSPFv3, with redistribution from EIGRP into OSPF configured with the redistribute eigrp 1 metric 25 command. Interface S0/0/1 has been enabled for EIGRP ASN 1. Which of the following should be true of redistribution in this case?（）D 2000::/64 [90/1422516]via FE80::213:19FF:FE7B:5026, Serial0/0/1C 2000:0:0:1::/64 [0/0]via Serial0/0/1, directly connectedL 2000::1:213:19FF:FE7B:5004/128 [0/0]via Serial0/0/1, receive
Router R1 lists the following output from a show command. Which of the following is true about R1?（）R1# show ip v6 interface f0/0FastEthernet0/0 is up, line protocol is upIPv6 is enabled, link - local address is FE80::213:19FF:FE12:3456No Virtual link - local address(es):Global unicast address(es):2000::4:213:19FF:FE12:3456, subnet is 2000:0:0:4::/64 [EUI]Jo ined group address(es):FF02::1FF02::2FF02::1:FF:12:3456
An Enterprise rou ter, Ent1, displays the following excerpt from the show ip bgp command. ENT1 has an eBGP connection to an ISP router with address 3.3.3.3 and an iBGP connection to a router with address 4.4.4.4. Which of the following is most likely to be true?（）Network Next Hop Metric LocPrf Weight Path*> 3.3.3.3 0 0 1 1 1 1 218 i
The following configuration exists on a router on one end of an IPv6 tunnel. Although the configuration added so far is correct, the configuration is incomplete. Which type of tunnel is most likely to be intended by the network engineer？（）interface loopback 1ip address 192.168.1.1 255.255.255.255interface tunnel 2ipv6 address 2002:C0A8:10 1::1/64tunnel source loopback 1
The following line of output was gathered on Enterprise Router Ent1 using the command show ip route. Which of the following answers is most likely to be true, based on thi s output？（）B 128.107.0.0 [20/10] via 11.11.11.11, 00:02:18