pany has implemented 802.1X authentication as a security enhancement.
Which statement is true about 802.1x port-based authentication？（）
A. TACACS+ is the only supported authentication server type.
B. If a host initiates the authentication process and does not receive a response， it assumes it is not authorized.
C. RADIUS is the only supported authentication server type.
D. Before transmitting data， an 802.1x host must determine the authorization state of the switch.
E. Hosts are required to havea 802.1x authentication client or utilize PPPoE.
F. None of the other alternatives apply.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit.
How will interface FastEthernnet0/1 respond when an 802.1x-enabled client connects to the port？ （）
A. The switch will uniquely authorize the client by using the client MAC address.
B. The switch will cause the port to remain in the unauthorized state， ignoring all attempts by the client to authenticate.
C. The switch port will disable 802.1x port-based authentication and cause the port to transition to the authorized state without any further authentication exchange.
D. The switch port will enable 802.1x port-based authentication and begin relaying authentication messages between the client and the authentication server.
An attacker is launching a DoS attack on the Company network using a hacking tool designed to exhaust the IP address space available from the DHCP servers for a period of time.
Which procedure would best defend against this type of attack？ （）
A. Configure only trusted interfaces with root guard.
B. Implement private VLANs （PVLANs） to carry only user traffic.
C. Implement private VLANs （PVLANs） to carry only DHCP traffic.
D. Configure only untrusted interfaces with root guard.
E. Configure DHCP spoofing on all ports that connect untrusted clients.
F. Configure DHCP snooping only on ports that connect trusted DHCP servers.
G. None of the other alternatives apply
The Company is concerned about Layer 2 security threats.
Which statement is true about these threats？ （）
A. MAC spoofing attacks allow an attacking device to receive frames intended for a different network host.
B. Port scanners are the most effective defense against dynamic ARP inspection.
C. MAC spoofing, in conjunction with ARP snooping, is the most effective counter-measure against reconnaissance attacks that use dynamic ARP inspection (DAI) to determine vulnerable attack points.
D. Dynamic ARP inspection in conjunction with ARP spoofing can be used to counter DHCP snooping attacks.
E. DHCP snooping sends unauthorized replies to DHCP queries.
F. ARP spoofing can be used to redirect traffic to counter dynamic ARP inspection.
G. None of the other alternatives apply.
Refer to the exhibit. Port security has been configured on the switch port Fa0/5.
What would happen if another device is connected to the port after the maximum number of devices has been reached， even if one or more of the original MAC addresses are inactive？（）
A. The port will permit the new MAC address because one or more of the original MAC addresses are inactive.
B. The port will permit the new MAC address because one or more of the original MAC addresses will age out.
C. Because the new MAC address is not configured on the port， the port will not permit the new MAC address.
D. Although one or more of the original MAC addresses are inactive， the port will not permit the new MAC address.
Refer to the exhibit.
What is the problem with this configuration？（）
A. Spanning tree PortFast cannot be configured on a port where a voice VLAN is configured.
B. Sticky secure MAC addresses cannot be used on a port when a voice VLAN is configured.
C. Spanning tree PortFast cannot be configured on a port when a sticky secure MAC address is used.
D. The switch port must be configured as a trunk.
最新試題
Which statement is correct about RSTP port roles？（）
During routine maintenance， G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However， after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ？ （）
Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port：00：06：34： %CDP-4-DUPLEX_MISMATCH： duplex mismatch discovered on FastEthernet0/5 （not half duplex）， with SW_A FastEthernet0/4 （half duplex） ， with TBA05071417（Cat6K-B） 0/4 （half duplex）. What would be the possible outcome of the problem？（）
What is the configured priority value of the Vlan105’s group on DS2 ？（）
What must be the same to make multiple switches part of the same Multiple Spanning Tree （MST）？（）
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2？（）
Refer to the exhibit. For what purpose is the command show ip cef used？（）
Which two statements are true when the extended system ID feature is enabled？ （）
Refer to the exhibit. Initially， LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements are true about the possible result of attaching the second link？（）
Refer to the exhibit. What does the command channel-group 1 mode desirable do？ （）