多項選擇題

A new switch is being installed and you have been assigned the task of connecting it to an existing switch. In doing this, you want to set up the VLAN Trunking Protocol so that VLAN information can be passed between the switches.
Which of the following must you do to accomplish this?（）

A. You must set each end of the trunk line to IEEE 802.1e encapsulation.
B. You must set the same VTP management domain name on both switches.
C. You must set all ports on the two switches as access ports.
D. You must configure one of the switches as a VTP server.
E. You must use a rollover cable to connect the two switches.


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題

You are bringing up a new Cisco Catalyst switch, and wish to connect it via a trunk to another switch from a different vendor, which uses the IEEE standard for the trunking method.
When setting the encapsulation type on the trunk, what should you configure on the Cisco switch?（）

A. Switch(config)# switchport trunk encapsulation isl
B. Switch(config)# switchport trunk encapsulation ietf
C. Switch(config-if)# switchport trunk encapsulation isl
D. Switch(config-if)# switchport trunk encapsulation ietf
E. Switch(config-if)# switchport trunk encapsulation dot1q

2.多項選擇題Which of the following steps are necessary in order to add a new VLAN to a switched network?（）

A. Create the VLAN.
B. Name the VLAN.
C. Configure an IP address for the VLAN.
D. Add the desired ports to the new VLAN.
E. Add the VLAN to the VTP domain.

3.多項選擇題Which router console commands are used to manage telnet sessions to other routers? （）

A. TestKingD# disconnect 3
B. TestKingD# exit session 2
C. TestKingD# kill connection 1
D. TestKingD# show sessions
E. TestKingD# show connection all
F. TestKingD# resume 4

4.單項選擇題

You wish to limit telnet access into your Cisco router to only a single host. In order to accomplish this, access list 1 has been written to allow host 172.16.1.224 access to the router vty lines.
What command would assign this access- list to the Virtual Terminal Lines?（）

A. router(config-line)# ip access-group 1 in
B. router(config-line)# access-class 1 in
C. router(config-line)# ip access-list 1 in
D. router(config-line)# access-line 1 in

5.多項選擇題You wish to increase the security of all of the routers within your network. What can be done to secure the virtual terminal interfaces on a router?（）

A. Administratively shut down the interface.
B. Physically secure the interface.
C. Create an access list and apply it to the virtual terminal interfaces with the access-group command.
D. Configure a virtual terminal password and login process.
E. Enter an access list and apply it to the virtual terminal interfaces using the access-class command.