A. Point-to-point
B. Broadcast multicast
C. Nonbroadcast multicast
D. Backbone area 0
E. Virtual Link
您可能感興趣的試卷
你可能感興趣的試題
A. The RIP route
B. The static route
C. The IGRP route
D. All three will load balance.
A. 15
B. 16
C. 99
D. 255
E. Unlimited
A. Neighbor Table
B. SRF Table
C. RTP Table
D. Topology Table
E. Query Table
F. Dual Table
A. Only routers can split boundaries (horizons) between networks in separate AS numbers.
B. Each AS must keep routing tables converged to prevent dead routes from being advertised across boundaries.
C. Once a route is received on an interface, advertise that route as unreachable back out the same interface.
D. Information about a route should never be sent back in the direction from which the original update came.
A. IGRP
B. CDP
C. OSPF
D. RIP v1
E. RIP v2
F. EIGRP
最新試題
Identify three valid host addresses in the 192.168.27.0 network with a subnet mask of 255.255.255.240. （）
What is a global command?（）
Which of the following contribute to congestion on an Ethernet network?（）
What is the subnetwork address for a host with IP address 201.100.5.68/28?（）
A network host is configured as follows: Host IP address: 192.168.16.183 Subnet mask: 255.255.255.224 Default gateway: 192.168.16.190 Which of the following statements describe the network to which this host is attached?（）
Which connections allow the use of full-duplex Ethernet?（）
Which command is used to display the placement and direction of an IP access control list on a router?（）
All WAN links is side the TestKing.com network use PPP with for authentication security. Which command will display the CHAP authentication process as it occurs between two routers in the network?（）
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? （）
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?（）