A.Router ACLs can be applied to the input and output directions of a VLAN interface
B.Bridged ACLs can be applied to the input and output directions of a VLAN interface
C.Only router ACLs can be applied to a VLAN interface
D.VLAN maps and router ACLs can be used in combination
E.VLAN maps can be applied to a VLAN interfac
您可能感興趣的試卷
你可能感興趣的試題
A.Trunk
B.Isolated
C.Primary
D.Community
E.Promiscuous
F.None of the other alternatives apply
Refer to the exhibit. The user who is connected to interface FastEthernet 0/1 is on VLAN 10 andcannot access network resources. On the basis of the information in the exhibit， which commandsequence would correct the problem？（）
A.SW1（config）# interface fastethernet 0/1 SW1（config-if）# no shut
B.SW1（config）# interface fastethernet 0/1 SW1（config-if）# switchport mode access SW1（config-if）# switchport access vlan 10
C.SW1（config）# vlan 10 SW1（config-vlan）# state active
D.SW1（config）# interface fastethernet 0/1 SW1（config-if）# switchport mode access
E.SW1（config）# vlan 10 SW1（config-vlan）# no shut
You work as a network Technician. A new workstation has consistently been unable to obtain anIP address from the DHCP server when the workstation boots. Older workstations function
normally， and the new workstation obtains an address when manually forced to renew its address.
What should be configured on the switch to allow the workstation to obtain an IP address at boot？（）
A.UplinkFast on the switch port connected to the server
B.BackboneFast on the switch port connected to the server
C.PortFast on the switch port connected to the workstation
D.trunking on the switch
A.Ports in VLAN 5
B.Utilization
C.VLAN information on port 0/5
D.Filters
E.MTU and type
Refer to the exhibit. On the basis of the output generated by the show commands， which twostatements are true？（）
A.All interfaces on the switch have been configured as access ports
B.Because it has not been assigned to any VLAN， interface gigabitethernet 0/1 does not appearin the show vlan output
C.Because it is configured as a trunk interface， interface gigabitethernet 0/1 does not appear inthe show vlan output
D.There are no native VLANs configured on the trunk
E.VLAN 1 will not be encapsulated with an 802.1q header
F.VLAN 2 will not be encapsulated with an 802.1q header
最新試題
As a network engineer， study the exhibit carefully. Router Net is unable to establish an ADSLconnection with its provider. Which action would correct this problem？（）
Match the xDSL type on the above to the most appropriate implementation on the below.
Which three statements accurately describe IOS Firewall configurations？（）
Drag the DSL local loop topic on the left to the correct descriptions on the right.
IPSec VPN is a widely-acknowledged solution for enterprise network. Which three IPsec VPNstatements are true？（）
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
In computer security， AAA stands for authentication， authorization and accounting. Which optionabout the AAA authentication enable default group radius enable command is correct？（）
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password？（）
Drag the IPsec protocol description from the above to the correct protocol type on the below.（Notall descriptions will be used）Drag and Drop question， drag each item to its proper location.