A.When traffic is sent from the ISP to autonomous system 64512， the traffic will be forwarded toSanJose2 because of the higher MED value of SanJose2
B.The serial 0/0/1 interface on the ISP router has been configured with the set metric 50command
C.The output was generated by entering the show ip bgp command on the SanJose1 router
D.The output was generated by entering the show ip bgp command on the ISP router
E.The serial 0/0/1 interface on the ISP router has been configured with the set metric 75command
F.When traffic is sent from the ISP to autonomous system 64512， the traffic will be forwarded toSanJose1 because of the lower MED value of SanJose1
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Router RT3 discovers network 202.176.56.0 via BGP. Which one of thesestatements is true？（）
A.RT1 advertised network 202.176.50.0/24 with a metric of 782
B.RT3 is directly connected to RT1 using subnet 192.168.1.0
C.RT3 has an IGP metric of 782 to reach 192.168.1.1
D.RT3 has a BGP metric of 782 to reach 192.168.1.1
E.RT1 advertised network 202.176.50.0/24 with a metric of 1000
F.RT3 has an IGP metric of 1782 to reach 202.176.56.0/24
A.Memory requirements are higher for shared distribution tree than for source distributiontree.
B.Creates a tree from a central RP to all last-hoprouters.
C.Uses a rendezvous point.
D.An optimal path is created between each source router and each last-hoprouter.
E.Place（S，G）entry in each router’smulticast routing table.
F.Place（*，G）entry in a router’smulticast routing to table.
Refer to the exhibit. Routers RTA and RTB are running BGP but the session is active. Whatcommand needs to be added to establish the BGP session？（）
A.ip route 10.10.10.1 255.255.255.255 s0/0 ip route 10.10.10.1 255.255.255.255 s0/1
B.network 10.10.10.0
C.no synchronization
D.neighbor 10.10.10.1 next-hop-self
A.Statically defined RP
B.Bootstrap Router
C.Auto-RP
D.RP Discovery Protocol（RDP）
E.RP Helios
F.RPARP（RARP）
A.Clear the BGP session
B.Change both the inbound and outbound policy related to this route
C.Use the service-policy command to adjust the QOS policy to allow the route to propagate
D.Use the release BGP routing command
最新試題
cisco ios command to interface dialer 0
Drag the IOS commands from the left that would be used to implement a GRE tunnel using the10.1.1.0.30 network on interface serial 0/0 to the correct target area on the right.
Which three statements accurately describe IOS Firewall configurations？（）
Which statement correctly describes IPsec VPN backup technology？（）
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）
Match the xDSL type on the above to the most appropriate implementation on the below.
As a network engineer， study the exhibit carefully. Router Net is unable to establish an ADSLconnection with its provider. Which action would correct this problem？（）
Drag the correct statements about MPLS-based VPN on the left to the boxes on the right.（Not allstatements will be used）
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clicking the numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible.To gain access to either the topology or the SDK click on the button to left side of the screen thatcorresponds to the section you wish to access. When you have finished viewing the topology theSDK you can return to your questions by clicking on the Questions button to the left.Which defined peer IP address an local subnet belong to Crete？（）