A.Following the traffic path
B.Top-down
C.Comparing configurations
D.Bottom-up
E.Divide and conquer
F.ExamineS LAs
您可能感興趣的試卷
你可能感興趣的試題
Which two of the following descriptions are correct according to the displayed output of thecommand show ip bgp summary？（）
A.The BGP session to the 10.1.1.1 neighbor is established
B.The router is trying to create a BGP peering session with the 10.1.1.1 neighbor
C.The BGP session to the 10.3.3.3 neighbor is created， but the router received no BGP routingupdates from the 10.3.3.3 neighbor
D.The router is attempting to establish a BGP peering session with the 10.2.2.2 neighbor
A.Extranet VPN
B.Managed overlay VPN topology
C.Hub-and-spoke VPN topology
D.Central-site VPN topology
E.Full mesh VPN topology
F.Remote-access VPN topology
A.The interface must be configured as a Multilink PPP interface.
B.The correct bandwidth should be configured on the interface.
C.A QoS policy must not be currently attached to the interface.
D.CEF must be enable
E.AutoQoS must be enabled globally before it can be enabled on the interface.
F.An IP address must be configured on the interface if its speed is equal to or less than 768 kbps.
A.show ip bgp
B.show ip bgp paths
C.show ip bgp peers
D.show ip bgp summary
E.show ip bgp protocols
A problem was reported that the 10.10.10.0/24 prefix was not injected into the local BGP table ona Company router named R1. The following information is available from this router：
R1 Configuration：
router bgp 65001
network 10.0.0.0
neighbor 172.16.1.1 remote-as 65002
no auto-summary
Routing table information：
show ip route | include 10
O 10.10.10.0/24 [110/11] via 192.168.1.1， 2d00h， Ethernet0/0
Why is this prefix not in the local BGP table of the R1？（）
A.The 172.16.1.1 neighbor is down.
B.The prefix 10.10.10.0/24 is not a ’connected’ route
C.This route is not a BGP learned route
D.The network command is wrong
E.None of the other alternatives apply
最新試題
In computer security， AAA stands for authentication， authorization and accounting. Which optionabout the AAA authentication enable default group radius enable command is correct？（）
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clicking the numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible.To gain access to either the topology or the SDK click on the button to left side of the screen thatcorresponds to the section you wish to access. When you have finished viewing the topology theSDK you can return to your questions by clicking on the Questions button to the left.Which defined peer IP address an local subnet belong to Crete？（）
IPSec VPN is a widely-acknowledged solution for enterprise network. Which three IPsec VPNstatements are true？（）
Drag the IOS commands from the left that would be used to implement a GRE tunnel using the10.1.1.0.30 network on interface serial 0/0 to the correct target area on the right.
Drag each element of the Cisco IOS Firewall Feature Set from the above and drop onto itsdescription on the below.
IPSec VPN is a widely-acknowledged solution for enterprise network. What are the four steps tosetup an IPsec VPN？（）
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.
Drag and drop each function on the above to the hybrid fiber-coaxial architecture component that itdescribes on the below.
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password？（）
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）