A. Never use passive interfaces.
B. Use NSSA areas from the core down.
C. Use totally stub areas to stop type 3 LSAs.
D. Use the lowest Ethernet interface IP address as the router ID.
E. Tune OSPF timers to enable OSPF to achieve quicker convergence
您可能感興趣的試卷
你可能感興趣的試題
A. Server-to-server traffic always remains in the core layer.
B. The recommended practice is for the core infrastructure to be in Layer 3.
C. The boundary between Layer 2 and Layer 3 should be implemented in the aggregation layer.
D. The Cisco Express Forwarding hashing algorithm is the default， based on the IP address andLayer 4 port.
E. Core layer should run BGP along with an IGP because iBGP has a lower administrativedistance than any IGP.
A. ASM
B. BiDir PIM
C. PIM-SM RP
D. RP-Switchover
E. Source Specific Multicast
A. 0
B. 1
C. 2
D. 4
E. 16
F. infinity
Refer to the exhibit. Which two statements are correct regarding the creation of a multicas tdistribution tree？ （）
A. Each router determines where to send the JOIN request.
B. The tree will be built based on the IP address of the E2 interface on router E
C. The best path to the source will be discovered in the unicast routing table on router B
D. The best path to the source will be discovered in the unicast routing table on router C
E. The best path to the source will be discovered in the unicast routing table on router E
A. a single host
B. a subset of hosts
C. all hosts sequentially
D. all hosts simultaneously
最新試題
What is the traditional mode for a firewall？（）
Which three mechanisms are used to secure management traffic from outside IPS sensors？（）
Which two design recommendations are most appropriate when EIGRP is the data center corerouting protocol？ （）
Which two statements about Network Attached Storage are correct？（）
Which signal and noise values will result in the best phone communication with an access point？（）
What are two characteristics of GSS？ （）
At a certain customer’s site， a NAS is both physically and logically in the traffic path. The NAS identifies clients solely based on their MAC addresses. In which access mode has this NAS been configured to operate？（）
Which two statements about Cisco Security Management Suite are correct？ （）
In which two locations in an enterprise network can an IPS sensor be placed？ （）
During consultation， you find that a customer has only a single asset closet and is looking for asolution that is easy to deploy. Which NAS physical deployment model would you suggest to this customer？（）