A. Bandwidth,Delay,and MTU
B. Bandwidth
C. Bandwidth and MTU
D. Bandwidth , MTU,Reliability,Delay,and Load
您可能感興趣的試卷
你可能感興趣的試題
A. reflexive
B. extended
C. standard
D. dynamic
A. redundant
B. spanned
C. provisioned
D. converged
A. NCP
B. LCP
C. ISDN
D. DLCI
E. SLIP
A. 10.188.31.0/27
B. 10.188.31.0/26
C. 10.188.31.0/29
D. 10.188.31.0/28
E. 10.188.31.0/25
A. Configure the switch to be in VTP client mode.
B. Configure the switch to be in VTP domaint mode.
C. Configure the switch to be in VTP transparent mode.
D. Configure the switch to be in VTPv2.
最新試題
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()
At which layer of the OSI model is RSTP used to prevent loops?()
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()
At which layer of the OSI model dose PPP perform?()
What is the purpose of the cisco Vlan Trunking protocol?()
Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?()