A. remote DLCI on the main interface
B. local DLCI on the main interface
C. local DLCI on the subinterface
D. remote DLCI on the subinterface
您可能感興趣的試卷
你可能感興趣的試題
A. traceroute address
B. tracert address
C. ssh address
D. telnet address
A. one
B. three
C. two
D. zero
A. The address is a broadcast address
B. The Ehernet interface is faulty
C. VLSM-capable routing protocols must be enable first on the router.
D. This address is a network address.
A. lowest port MAC address
B. port priority number and MAC address.
C. VTP revision number
D. highest port priority number.
E. path cost
A. Enable VTP pruning
B. From privileged mode ,erase the startup configuration file,then reload.
C. From privileged mode ,erase the vlan date file, then reload.
D. Cycle the switch power.
最新試題
An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?（）
Three access ports have been installed and configured to a small office.What term defines the wireless topology?（）
What is the default administrative distance of OSPF?（）
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
How are VTP advertisements delivered to switches across the network?（）
Which pairing reflects a correct protocol-and-metric relationship?（）
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?（）
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?（）