A. enable cdp
B. cdp enable
C. cdp run
D. run cdp
您可能感興趣的試卷
你可能感興趣的試題
A. ip route 172.16.1.0 255.255.255.0 0.0.0.0
B. ip route 172.16.1.0 255.255.255.0 172.16.2.1
C. ip route 0.0.0.0 255.255.255.0 172.16.2.1
D. ip route 0.0.0.0 0.0.0.0 172.16.2.1
A. NVRAM
B. RAM
C. FLASH
D. ROM
E. PCMCIA
A. copy running-config: TFTP:
B. copy TFTP: running-config
C. copy TFTP: startup-config
D. copy startup-config: TFTP:
A. copy running-config startup-config
B. copy startup-config: running-config
C. copy running config startup config
D. copy startup config running config
E. write terminal
A.10.1.1.1
B.127.0.0.1
C.192.168.0.1
D.239.1.1.1
最新試題
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()
How are VTP advertisements delivered to switches across the network?()
Which command is used to display the collection of OSPF link states?()
At which layer of the OSI model is RSTP used to prevent loops?()
Three access ports have been installed and configured to a small office.What term defines the wireless topology?()
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?()
Which command displays the CHAP authentication process as it occurs between two routers?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()