多項選擇題Which two data link layers are supported by cisco ios software for IPv6?()

A.PPP
B.FDDI
C.Frame Relay PVC
D.NBMA
E.Frame Relay SVC


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題Which three statements accurately describe layer 2 Ethernet switches?()

A. Microsegmentation decreases the number of collisions on the network.
B. if a switch receives a frame for an unkown destination,it uses ARP to resolve the address.
C. Spanning Tree Protocol allows switches to automatically share vlan information.
D. In a properly functioning network with redundant switched paths,each switched aegment will contain one root bridge with all its ports in the forwarding state.All other switches in that broadcast domain will have only one root port.
E. Establishing vlans increases the number of broadcast domains.
F. Switches that are configured with vlans make forwarding decisions based on both layer 2 and layer 3 address information.

2.多項選擇題Which two commands can be used to verify a trunk link configurationt status on a given cisco switch?()

A. show interfaces interface
B. show interfaces interface trunk
C. show interfaces interface switchport
D. show ip interface brief
E. show interfaces vlan

3.多項選擇題Which commands are required to properly configure a router to properly configure a router to run OSPF and to add network 192.168.16.0/24 to OSPF area 0?()

A. Router(config)#router ospf 1
B. Router(config)#router ospf 0
C. Router(config)#router ospf area 0
D. Router(config-router)#network 192.168.16.0 0.0.0.255 area 0
E. Router(config-router)#network 192.168.16.0 0.0.0.255 0
F. Router(config-router)#network 192.168.16.0 255.255.255.0 area 0

4.多項選擇題Which two statements describe the advantages to the use of RIP over the use of OSPF?()

A. RIP requires less time to converge
B. RIP uses less bandwidth
C. RIP is less complex to configure
D. RIP demands fewer router resources
E. RIP has a more accurate metric

5.多項選擇題Which three elements must be used when you configure a router interface for vlan trunking?()

A. one IP network or subnetwork for each subinterface
B. subinterface numbering that matches vlan tages
C. subinterface encapsulation identifiers that match vlan tags
D. a management domain for each subinterface
E. one physical interface for each subinterface
F. one subinterface per vlan

最新試題

A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?()

題型:單項選擇題

Which statement is true, as relates to classful or classless routing?()

題型:單項選擇題

What is the purpose of the cisco Vlan Trunking protocol?()

題型:單項選擇題

Which command encrypts all plaintext passwords?()

題型:單項選擇題

Which pairing reflects a correct protocol-and-metric relationship?()

題型:單項選擇題

Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?()

題型:單項選擇題

Three access ports have been installed and configured to a small office.What term defines the wireless topology?()

題型:單項選擇題

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()

題型:單項選擇題

What is the default administrative distance of OSPF?()

題型:單項選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型:單項選擇題