A.It is a function used by routing protocols to install routes into routing table
B.It is a function that prevents the advertising of routes over an interface that the router is usingto reach a route
C.Its function is to help avoid routing loops.
D.It is a redistribution technique used by routing protocols
您可能感興趣的試卷
你可能感興趣的試題
A.An update packet with init flag set from a known， already established neighbor relationship was received by one of the routers.
B.The counters were deleted.
C.The ARP cache was removed.
D.The IP EIGRP neighbor relationship was cleared manually.
A.Area 0
B.NSSA
C.Totally stubby
D.Stub
A.Set the NHRP hold time to match the EIGRP hold time
B.Add the enable eigrp stub command
C.Add the disable eigrp as-member split-horizon command
D.Add the disable eigrp as-member next-hop-self command
A.NBAR provides the ability to configure MCQ； it is a mandatory MCQ component.
B.NBAR provides deep packet inspection and is used for advanced packet classification.
C.NBAR provides per-protocol packet and byte accounting functionality； it is used to track bandwidth utilization for all protocols described in the loaded PDLMs.
D.NBAR provides scheduling in an MQC policy map using an advanced algorithm.
A.IP ToS of 0xEF
B.IP experimental ECN
C.DSCP decimal 5
D.Binary value of 101110
最新試題
What does a unicast prefix-based IPv6 multicast address start with？（）
Policy-based routing allows network administrators to implement routing policies to allow or deny paths based on all of these factors except which one？（）
Which switch port error is an indication of duplex mismatches on 10/100/1000 IEEE 802.3u Gigabit Ethernet ports？（）
What does the OSPF command capability vrf-lite achieve？（）
In GLBP， which router will answer on client ARP requests？（）
You are the network administrator of a Layer 3 switched network. Users in one VLAN are complaining that access to the server VLAN is very slow from time to time. Traffic in the local VLAN works without any issue， and users in other VLANs do not have any complaint to reach the server VLAN. What is most likely the cause of this issue？（）
Two directly connected routers， R1 and R2， are both configured for OSPF graceful restart. R2 is able to switch packets in hardware， but R1 is not. If a network administrator logs on to R2 and performs a system reload， which will be the result？（）
What are the "bound IP addresses" used for in LDP？（）
f a Cisco switch is configured with VTPv1 in transparent mode， what is done with received VTP advertisements？（）
Choose two commands that are required to enable multicast on a router， when it is known that the receivers use a specific functionality of IGMPv3.（）