A.ip sla monitor low-memory
B.ip sla group schedule
C.ip sla reaction-trigger
D.ip sla enable timestamp
您可能感興趣的試卷
你可能感興趣的試題
A.Upgrade the switches
B.Configure BPDU guard
C.Configure VLAN access lists
D.Configure port security
E.Configure Dynamic ARP inspection
A.Enable bpduguard globally.
B.Enable rootguard.
C.Enable loopguard.
D.Enable spanning tree.
E.Enable UDLD
A.Change your Internet provider.
B.Change your public IP address.
C.Allow the email server to send traffic only to TCP port 25.
D.Put your email server in a DMZ.
E.Use a separate public IP address for your email server only.
A.Increase memory allocation for ACLs.
B.Remove all entries from the ACL and use a single permit ip any any statement.
C.Remove the log keyword from each ACL entry.
D.Reboot the device after the ACL has been applied.
A.IPSec VPN
B.SSL VPN
C.port security
D.port security with statically configured MAC addresses
E.private VLANs
最新試題
Which one of the following potential issues is eliminated by using split horizon？（）
Which statement best describes OSPF external LSAs （type 5）？（）
Which router is doing LSA type 7 to type 5 translation，and why？（）
Multicast is being deployed in the network， and only ip pim sparse-dense mode has been configured on all interfaces in the network to support a new video streaming application. No other multicast configuration was applied anywhere in the network. Since enabling multicast， the network monitoring tools show periodic spikes in link utilization throughout the network， even in areas where the video application is not being used. What could be a possible cause？（）
In which way can the IPv6 address of 2031：0000：130F：0000：0000：09C0：876A：130B be expressed most efficiently？（）
What does a unicast prefix-based IPv6 multicast address start with？（）
Phase I and Phase II DMVPN differ in terms of which of these characteristics？（）
IEEE 802.1w is a Rapid Spanning Tree Protocol （RSTP） that can be seen as an evolution of the 802.1 standard. What are the port roles described by 802.1w？（）
An administrator of a peer-to-peer server application reports that the maximum bandwidth that his application receives is 90 Mb/s. You have an 8-port，100-Mb/s EtherChannel bundle on the switching infrastructure between the two servers， resulting in a bidirectional throughput of more than what is recorded. Which two solutions would allow for more bandwidth for the application？（）
Which three protocols should be explicitly managed by using Control Plane Policing on an Internet border router？（）