多項選擇題A national retail chain needs to design an IP addressing scheme to support a nationwide network. The company needs a minimum of 300 sub-networks and a maximum of 50 host addresses per subnet. Working with only one Class B address, which of the following subnet masks will support an appropriate addressing scheme?()

A.255.255.255.0
B.255.255.255.128
C.255.255.252.0
D.255.255.255.224
E.255.255.255.192
F.255.255.248.0


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題

Use the output from the router shown in the graphic above to determine which of the following are correct.()

A. Router John uses a link-state routing protocol.
B. Router John will receive routing updates on the Serial0/0 interface.
C. Router John will receive routing updates on the Serial0/1 interface.
D. Router John will send routing updates out the Serial0/0 interface.
E. Router John will send routing updates out the FastEthernet0/0 interface.
F. Router John will send routing updates out the Serial0/1 interface.

2.多項選擇題

Which of the following statements describe the network shown in the graphic?()

A. There are two broadcast domains in the network.
B. There are four broadcast domains in the network.
C. There are six broadcast domains in the network.
D. There are four collision domains in the network.
E. There are five collision domains in the network.
F. There are seven collision domains in the network.

3.多項選擇題Which characteristics are representative of a link-state routing protocol?()

A. provides common view of entire topology
B. exchanges routing tables with neighbors
C. calculates shortest path
D. utilizes event-triggered updates
E. utilizes frequent periodic updates

4.多項選擇題Which of the following statements are true regarding bridges and switches?()

A. Switches are primarily software based while bridges are hardware based.
B. Both bridges and switches forward Layer 2 broadcasts.
C. Bridges are frequently faster than switches.
D. Switches have a higher number of ports than most bridges.
E. Bridges define broadcast domains while switches define collision domains.
F. Both bridges and switches make forwarding decisions based on Layer 2 addresses.

5.多項選擇題What are some of the advantages of using a router to segment the network?()

A. Filtering can occur based on Layer 3 information.
B. Broadcasts are eliminated.
C. Routers generally cost less than switches.
D. Broadcasts are not forwarded across the router.
E. Adding a router to the network decreases latency.

最新試題

Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?()

題型:單項選擇題

A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?()

題型:單項選擇題

Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?()

題型:單項選擇題

A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()

題型:單項選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型:單項選擇題

Which statement describes the rule of split horizon?()

題型:單項選擇題

Which statement is true, as relates to classful or classless routing?()

題型:單項選擇題

Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()

題型:單項選擇題

Which command encrypts all plaintext passwords?()

題型:單項選擇題

If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()

題型:單項選擇題