Refer to the exhibit. There are two sites connected across WAN links. All intersite and intrasite links always have the same routing metric. The network administrator sees only the top routers and links being used by hosts at both LAN A and LAN B. What would be two suggestions to load-balance the traffic across both WAN links?()
A.Make HSRP track interfaces between the edge and core routers.
B.Replace HSRP with GLBP.
C.Add crossed intrasite links: R1-R4, R2-R3, R5-R8, and R6-R7.
D.Make R3 and R8 have lower HSRP priority than R1 and R7.
E.Replace HSRP with VRRP
您可能感興趣的試卷
你可能感興趣的試題
三臺路由器,問:在路由器B(即中間的那臺路由器)上的E0/1的IN方向做一個ACL,要求路由器A可以TELNET路由器C,但是路由器C不可以TELNET路由器A。要求寫出ACL命令行。
A.ping 192.168.1.255
B.ping with sweep option
C.ping 192.168.1.127
D.ping 192.168.1.64
E.ping with broadcast option
A.OSPF standard hellos
B.Cisco Discovery Protocol link detection
C.Bidirectional Forwarding Detection
D.Fast Link Pulse
E.autonegotiation
Refer to the exhibit. R2 and R3 are routers connected using Ethernet services from a service provider and can receive pings from each other. OSPF is configured as the routing protocol but adjacency is not happening. According to the output of the show commands in the exhibit, what could be the most likely cause of the problem?()
A.Ethernet interfaces were configured as point-to-point.
B.Process IDs are not matching.
C.Configured bandwidths do not match on both interfaces.
D.Broadcasts and multicast are not being propagated over the Ethernet services.
E.OSPF cost does not match on both interfaces.
最新試題
QoS機制中的分類,采用ip數據包中的哪個字段?
QoS Mechanisms:問在部署QoS中要用的3個mechanisms是什么?
What is method list for configure aaa?
aaa架構中哪個是要求用戶輸入用戶名和密碼?
SPT初始狀態之后的一個狀態是什么?
what is the disadvantage of policing?
Refer to the exhibit.What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?()
什么問題導致SERVER VTP密碼跟替他交換機VTP密碼不匹配?
R1 will choose which path to reach 10.1.0.0?
What is the three main step of using the QoS feature with MQC command line interface?