A.The phones are not sending traffic with the correct DSCP value.
B.The Cisco CallManager is not marking the traffic correctly.
C.This is most likely a bug on the CE routers.
D.Your LAN QoS is incorrectly configured.
您可能感興趣的試卷
你可能感興趣的試題
A.routing issue
B.denial-of-service attack
C.MAC flooding
D.spanning-tree recalculation
E.Layer 2 loop
F.ARP spoofing attack
A. The switches are not the same model
B. You are not using the correct SFP
C. You are not using correct optical media converters
D. Configuration should be modified， because the distance is longer
A. Tunnel IPv6 over IPv4 to connect far-end IPv6 networks
B. Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possible
C. Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possible
D. What is the meaning of EUI-64 and how does it work？
E. Tunnel IPv4 over IPv6 to connect far-end IPv4 networks.
A.NTP updates are sent in the timezone they are collected in，and the syslog server will adjust based on the input time.
B.NTP authentication verifies the source，not the recipient.
C.NTP authentication requires that the recipient has multiple strata clocks to ensure accuracy.
D.Secure NTP can be configured to use SHA-1 hashing，since NTP is very insecure.
E.A stratum 0 clock should be configured at the core of every network，so it can connect to an accuratetime source.
Refer to the exhibit. You are setting up a 2-gigabit EtherChannel. Following IEEE standards， the exhibit shows your configuration in a local switch1. However， EtherChannel is not coming up. Which one of these statements could be a possible reason？（）
A. EtherChannel is only available in Cisco equipment.
B. The customer side is supposed to be running PAgP, which is a Cisco standard.
C. PAgP is not an IEEE standard. VRRP should be used.
D. The configuration on switch1 needs to be modified to use LACP.
最新試題
Which three options are valid ways to filter routes from a BGP peer？（）
In Layer 2 topologies， spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions？（）
Based on the output provided in the exhibit， to which address or location will the router forward a packet sent to 192.168.32.1？（）
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree ProtocolIEEE 802.1 D？（）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link，but only allow eachindividual flow to use 1 MB/s？（）
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0？（）
Choose two commands that are required to enable multicast on a router， when it is known that thereceivers use a specific functionality of IGMPv3.（）
On the basis of the network provided in the exhibit， all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails， what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24， assuming that all the packets sent during convergence are transmitted once （there are no dropped or retransmitted packets）？（）
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）
In order to configure two routers as anycast RPs， which of these requirements， af a minimum， must besatisfied？（）